呼和浩特摩托车科目四英语试题

1. The motorized vehicle driver may go through an intersection rapidly when there is no traffic signal

A. Right

B. Wrong

Answer: B

2. What is the meaning of this sign?

A. Crosswalk

B. Students’ passage

C. Watch for pedestrians

D. Children’s passage

Answer: A

3. When encountering this situation in a residential area, the driver may honk to urge them to yield.

A. Right

B. Wrong

Answer: B

4. The article that cannot be used to stop bleeding by dressing is _________.

A. Bondage

B. Sling

C. Tourniquet

D. Hemp rope

Answer: D

5. In emergencies, people’s life safety should always be put in the first place.

A. Right

B. Wrong

Answer: A

6. How to ensure motor vehicles have sufficient power when driving uphill?

A. Downshift before reducing speed

B. Downshift after reducing speed

C. Downshift when the speed is excessively low

D. Downshift to the fullest extent

Answer: A

7. It is not a bad habit for a driver to frequently change lanes.

A. Right

B. Wrong

Answer: B

8. A correct measure to avoid tire burst of motor vehicles is to lower the tire pressure.

A. Right

B. Wrong

Answer: B

9. When rescuers enter the scene to rescue the wounded after harmful gas leakage caused by traffic accidents, they must wear air respirators or cover their mouth and nose with wet towels.

A. Right

B. Wrong

Answer: A

10. When a motorcycle reaches a muddy or burst-and-muddy section, the driver should stop, observe and select the level and solid section or the section with vehicle tracks.

A. Right

B. Wrong

Answer: A

11. The motor vehicle should speed up and pass rapidly under this situation.

A. Right

B. Wrong

Answer: B

12. Motor vehicle drivers may borrow a special lane for other vehicle types, if one exists, to overtake.

A. Right

B. Wrong

Answer: B

13. Driving a motor vehicle in the downhill section of a mountain road avoids overtaking as much as possible because _______.

A. Vehicle resistance in downhill section is very high

B. Vehicles on downhill sections are more difficult to control than on flat roads due to gravity.

C. In downhill section, the front speed is faster and it is difficult to overtake.

D. Vehicles on downhill sections tend to be too fast due to gravity

Answer: BD

14. What is the meaning of this sign?

A. Bump road

B. Low-lying road

C. High outburst road

D. Hump bridge

Answer: B

15. What is the meaning of this sign?

A. No long time honking

B. Honk discontinuously

C. Reduce speed and honk

D. No honking

Answer: D

16. When a bicycle borrows the motor vehicle lane, the motor vehicle may sound the horn hurriedly to warn the bicycle to yield.

A. Right

B. Wrong

Answer: B

17. When such circumstances happen suddenly, what should the driver do?

A. Reduce speed or stop to yield

B. Bypass in front of the pedestrians

C. Continuously sound the horn to alert the pedestrians

D. Bypass from behind the pedestrians

Answer: A

18. If a driver finds there is no vehicle behind, he/she may change lanes without turning on the indicator.

A. Right

B. Wrong

Answer: B

19. When a wounded person is unable to get off the vehicle by himself, he should be removed from the vehicle so as to avoid a secondary injury.

A. Right

B. Wrong

Answer: A

20. When passing a turn or a curve section, the driver should slow down and disengage the clutch.

A. Right

B. Wrong

Answer: B

21. How to reduce speed or stop when driving on a road covered with snow and ice?

A. Take full advantage of driving brake

B. Take full advantage of the control power from engine

C. Take full advantage of parking brake

D. Take full advantage of speed retarder

Answer: B

22. What is the meaning of this sign?

A. Slippery section

B. Sharp curve

C. Inverse curve

D. Continuous curves

Answer: C

23. What marking is the road mark?

A. Crosswalk ahead

B. Intersection ahead

C. Reduce speed and yield ahead

D. Stop to yield ahead

Answer: A

24. When a motor vehicle temporarily stops in fog, which lamp should be turned on?

A. Hazard lamp, clearance lamp and rear position lamp

B. Left-turn indicator, clearance lamp and rear position amp

C. Headlamp, clearance lamp and rear position lamp

D. Reverse lamp, clearance lamp and rear position lamp

Answer: A

25. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D