大庆驾考英文

1. Ignition switch in the ON position, the vehicle can not use electrical appliances.

A. Right

B. Wrong

Answer: B

2. Which part does it control when rotating this part of the switch?

A. the low beam lights

B. the head and tail fog lights

C. high beam lights

D. turn signals

Answer: B

3. How far should be the distance from the vehicle in front at the speed of more than 100 km/hr when driving a small passenger vehicle on the expressway?

A. more than 50 meters

B. more than 60 meters

C. more than 100 meters

D. more than 80 meters

Answer: C

4. A motorized vehicle is not allowed to stop in the section 50 meters to the narrow road less than 4 meters width.

A. Right

B. Wrong

Answer: A

5. When a vehicle approaches a bus stopping at a bus stop, the driver should ______ in case the bus starts up suddenly or pedestrians cross in front of the bus.

A. Reduce speed, keep a sufficient distance and be ready to stop anytime

B. Maintain the normal speed

C. Honk to remind, speed up and pass

D. Be ready to apply emergency braking

Answer: A

6. Whats the meaning of this sign?

A. reduce speed in tunnel

B. turn on the high beam lights in tunnel

C. turn on the light in tunnel

D. width light in tunnel

Answer: C

7. Whats the meaning of the white horizontal solid line in the circle?

A. turning waiting line

B. deceleration line

C. yielding line

D. stop line

Answer: D

8. This small car can not stop here.

A. Right

B. Wrong

Answer: A

9. No running into the middle lane when encountering this situation.

A. Right

B. Wrong

Answer: A

10. How to use lights at night while crossing each other on narrow road or bridge?

A. turn off all the lights

B. turn on the low beam lights

C. turn off the head lights

D. turn on high beam lights

Answer: B

11. Whats the meaning of this sign?

A. bypass at construction section

B. two-way traffic

C. bypass from left or right side

D. watch for danger

Answer: C

12. Which part does it control when pulling this switch?

A. turn signals

B. reverse light

C. contour light

D. hazard light

Answer: A

13. At night, the drivers observation is markedly poorer than in the daytime and the range of visibility range is _______.

A. Unchanged

B. Irregular

C. Longer

D. Shorter

Answer: D

14. Whats the meaning of this sign?

A. reducing speed 40m ahead

B. minimum speed is 40km/hr

C. axle weight limit is 40 tons

D. maximum speed limit is 40km/hr

Answer: D

15. When crossing each other on a narrow road, the driver should slow down, yield and stop first.

A. Right

B. Wrong

Answer: A

16. When driving during the period of probation, the driver should paste or hang _____ on the rear part of the vehicle

A. a mark of avoiding with care

B. a mark of paying attention of beginner

C. a uniform probation mark

D. a mark of paying attention of vehicle distance

Answer: C

17. When a vehicle changes lane, the driver only needs to turn on the turn signal before rapidly entering the new lane.

A. Right

B. Wrong

Answer: B

18. Whats the meaning of this sign?

A. right-turn lane

B. U turn lane

C. left-turn lane

D. straight-going lane

Answer: D

19. You may speed up to go through the intersection in this case.Answer：

A. Right

B. Wrong

Answer: B

20. What dangerous acts cant the driver conduct when driving downhill?

A. slide the vehicle in the neutral gear

B. driving in lower gear

C. braking to reduce speed

D. changing to the lower gear in advance

Answer: A

21. Whats the meaning of this sign?

A. low-lying road

B. hump bridge

C. bump road

D. high outburst road

Answer: C

22. Using the high and low beam lights alternately while driving on the road of this kind of sharp curve.

A. Right

B. Wrong

Answer: A

23. Whats the meaning of this sign?

A. no U turn at intersection

B. no changing lane from both sides

C. no left or right turn

D. no going straight

Answer: C

24. It lights continuously to indicate that airbag is working.

A. Right

B. Wrong

Answer: B

25. How to use lights when pulling over on road?

A. turn on the hazard lights

B. turn on the right-turn signal in advance

C. use the high and low beam lights alternately

D. not need to use any light to indicate

Answer: B