长治摩托车英文题库PDF电子版

1. When a motorcycle is making a turn in a high speed, the driver should avoid using the brake or use the brake less to prevent sideslip.

A. Right

B. Wrong

Answer: A

2. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D

3. What is the meaning of this sign?

A. stopping temporarily is allowed

B. long stopping is allowed

C. no long stopping

D. no stopping

Answer: D

4. Turning on the high-beam is an effective way to improve visibility in fog weather.

A. Right

B. Wrong

Answer: B

5. Motor vehicle drivers don’t need to use any lamp at night when passing through a road section where the street light condition is good.

A. Right

B. Wrong

Answer: B

6. When driving a motor vehicle into a traffic flow, drivers should not hold up other vehicles.

A. Right

B. Wrong

Answer: A

7. A person who has not obtained driving license drives a motorized vehicle, he will be held for legal liability.

A. Right

B. Wrong

Answer: A

8. How to use lights when overtaking at night?

A. turn off the high beam light

B. turn on high beam lights

C. use fog lights

D. using the high and low beam lights alternately

Answer: D

9. Which lamp should be used when motor vehicles pass hrough an intersection at night where there is no traffic light signal?

A. High-beam

B. Low-beam

C. Hazard lamps

D. High-beam and low-beam should be used alternatively

Answer: D

10. How to drive through the intersection without traffic lights?

A. reduce speed and go slowly

B. speed up and pass

C. let large vehicle go first

D. let the left vehicle go first

Answer: A

11. When driving on a long downhill road, which is the best way to control driving speed?

A. Coast in neutral gear

B. Depress the clutch and coast

C. Use the engine to brake

D. Depress the brake pedal continuously

Answer: C

12. When driving on a road covered with ice and snow, the motor vehicle may spin or slide when increasing the speed urgently, due to the loss of vehicle stability.

A. Right

B. Wrong

Answer: A

13. How will the adhesive force of road change when speed increases on a damp and slippery road?

A. Increase sharply

B. increase gradually

C. decrease sharply

D. No change

Answer: C

14. When a rear tire of a motorcycle blows out, the driver should ________.

A. Swiftly turn the steering handlebar to adjust

B. Firmly hold the steering handlebar with both hands

C. Swiftly turn the steering handlebar to the opposite direction

D. Swiftly take braking measures

Answer: B

15. A motorized vehicle is not allowed to stop in the section 50 meters to the bridge, steep slope or tunnel.

A. Right

B. Wrong

Answer: A

16. In which situation the traffic police may detain the vehicle?

A. no lable of inspection

B. no ID card

C. no lable of environmental protection

D. no vehicle registration papers

Answer: A

17. If a motorized vehicle driver chases and races while driving on road, commits serious acts, the driver is subject to a prison term of less than 3 years.

A. Right

B. Wrong

Answer: B

18. If a motorized vehicle runs 50% faster than the specified speed limit, the driver is subject to a 3-point penalty.

A. Right

B. Wrong

Answer: B

19. A motorized vehicle driver who deliberately covered or stained the license plate and placed the license plate unproperly, is subject to a ________.

A. 2-point penalty

B. 3-point penalty

C. 6-point penalty

D. 12-point penalty

Answer: D

20. A driver can park the vehicle by borrowing the sidewalk if he cannot find the parking area.

A. Right

B. Wrong

Answer: B

21. Violent wind can cause a sideways swerve to a running vehicle.

A. Right

B. Wrong

Answer: A

22. When a motorcycle turns at an excessively high speed, it can easily dash out of a curve or skid sideways.

A. Right

B. Wrong

Answer: A

23. When a motor vehicle stops in snow, which lamp should be turned on?

A. Front and rear fog lamps, clearance lamp and rear position lamp

B. Reverse lamp, clearance lamp and rear position lamp

C. Headlamp, clearance lamp and rear position lamp

D. Hazard lamps, clearance lamp and rear position lamp

Answer: D

24. Which one of the following measures is correct when a motor vehicle intends to overtake but the vehicle infront refuses to yield?

A. Use a long-sounding horn

B. Follow the vehicle in front while turning high-beam

C. Wait for it to yield while keeping a safe distance

D. Use high-beam and low-beam alternatively

Answer: C

25. How to use lights when pulling over on road?

A. turn on the hazard lights

B. turn on the right-turn signal in advance

C. use the high and low beam lights alternately

D. not need to use any light to indicate

Answer: B