楚雄摩托车科目四考试英文

1. When the tire pressure is too low, what can happen when driving at a high speed?

A. Tire pressure will be unstable

B. Tire pressure will increase

C. Driving resistance will decrease

D. The tire will burst

Answer: D

2. When a motorcycle goes downhill, it may fully use the neutral gear and slide.

A. Right

B. Wrong

Answer: B

3. When a tire blowout on the road, the driver should control the direction of the vehicle and use emergency braking to bring the motorcycle swiftly to a stop.

A. Right

B. Wrong

Answer: B

4. What is the most frequent problem for driving on a muddy road?

A. High resistance force

B. Sideways slide

C. The motor vehicle bumps

D. Steering failure

Answer: B

5. When driving on a rough road, the driver should use low gear to keep low speed; try to choose roads with big pits to reduce bumpy feeling.

A. Right

B. Wrong

Answer: B

6. What is the meaning of this sign?

A. Turn left

B. No going straight

C. Straight-going lane

D. One-way road

Answer: A

7. When a motorcycle braking on a road covered by ice and snow, the driver should adopt point braking and prepare their feet for landing when braking.

A. Right

B. Wrong

Answer: A

8. What is the meaning of this sign?

A. No long time honking

B. Honk discontinuously

C. Reduce speed and honk

D. No honking

Answer: D

9. When driving in rain and encountering pedestrians with umbrellas or wearing raincoats, what should be done by motor vehicle drivers in order to yield?

A. Drive at a normal speed

B. Sound the horn to alert when approaching the pedestrians

C. Speed up and bypass on the left

D. Reduce speed and sound the horn in advance

Answer: D

10. What is the meaning of this sign?

A. Driving at reduced speed in the section of 40 meters

B. Minimum speed is 40km/hr

C. Maximum speed is 40km/hr

D. 40km/hr speed limit ban is lifted

Answer: D

11. According to regulations, motorcycle driver should wear _______.

A. Glasses

B. A special safety helmet

C. Gloves

D. Safety kneepads

Answer: B

12. When the engine suddenly stalls on the road, what should the driver do?

A. Stop the vehicle and overhaul it immediately

B. Immediately turn on the hazard lamps

C. Move the vehicle to a place where it will not obstruct the traffic flow

D. Set up a breakdown warning sign

Answer: BCD

13. Which measures is correct when a motor vehicle turn around?

A. Turn around in the turning lane

B. Should not turn on the turning light

C. Turn around in the straight lane

D. Turn on the left-turn signal in advance

Answer: AD

14. When a motorcycle turns at an excessively high speed, it can easily dash out of a curve or skid sideways.

A. Right

B. Wrong

Answer: A

15. The motorized vehicle driver may go through an intersection rapidly when there is no traffic signal

A. Right

B. Wrong

Answer: B

16. When driving a motor vehicle into a traffic flow, drivers should not hold up other vehicles.

A. Right

B. Wrong

Answer: A

17. When driving on road sections where safe sight distance is affected, such as the top of a ramp, what should drivers do to ensure safety?

A. Rush through

B. Use hazard lamp

C. Cut speed and sound the horn

D. Drive at will

Answer: C

18. Which of the following measures is incorrect when a motor vehicle stops?

A. Stop at a stipulated place

B. Avoid stopping on pedestrian streets

C. Avoid obstructing the passing of other motor vehicles and pedestrians when temporarily stops on the road

D. Stop on the non-motor vehicle lane

Answer: D

19. There is a risk of overtaking when driving a motor vehicle approaches the top of the slope on a mountainous road, because _____.

A. When approaching the top of the slope, the line of sight is blocked and it is impossible to observe the traffic situation.

B. When approaching the top of the slope, the line of sight is blocked. It is impossible to observe whether there are obstacles behind the top of the slope.

C. The speed is slower when approaching the top of the slope.

D. When approaching the top of the slope, the line of sight is blocked and the road direction behind the top of the slope can not be observed.

Answer: ABD

20. Driving a motor vehicle in the downhill section of a mountain road avoids overtaking as much as possible because _______.

A. Vehicle resistance in downhill section is very high

B. Vehicles on downhill sections are more difficult to control than on flat roads due to gravity.

C. In downhill section, the front speed is faster and it is difficult to overtake.

D. Vehicles on downhill sections tend to be too fast due to gravity

Answer: BD

21. Which is correct when riding a motorcycle

A. Both hands can temporarily leave the steering handle bar

B. Voluntarily operate the steering handle bar

C. It is prohibited to simultaneously move two hands from the steering handle bar

D. It is able to statically turn the steering handle bar

Answer: C

22. When a motorcycle reaches a muddy or burst-and-muddy section, the driver should stop, observe and select the level and solid section or the section with vehicle tracks.

A. Right

B. Wrong

Answer: A

23. What is the purpose of checking before driving?

A. Confirm whether the tyres of motor vehicles are damaged or not

B. Confirm whether there is a safety hazard near the vehicle.

C. Confirm whether there are obstacles around the vehicle

D. Confirm whether the road in front of the vehicle is safe

Answer: ABCD

24. How should lamps be used when motor vehicle drivers pass through a two-way tunnel?

A. Turn on the hazard lamps

B. Turn on the high-beam

C. Turn on the fog lamp

D. Turn on the low-beam

Answer: D

25. When rescuing a wounded person suffering from bone fracture, which of the following should be kept in mind?

A. Immediately send him/her to the hospital on a stretcher

B. Properly change the original posture when the injured person wounded

C. Dress the fracture with a bandage

D. Do not move the fractured body-part

Answer: D