阿勒泰摩托车科目四考试英文

1. The continuously flashing yellow light is to warn that the driver should look and make sure it is safe to pass.

A. Right

B. Wrong

Answer: A

2. Whats the meaning of this mark on the road?

A. The lane for non-motorized vehicles

B. The special lane for motorcycles

C. The special lane for battery bicycles

D. the special lane for bicycles

Answer: A

3. A correct measure to avoid tire burst of motor vehicles is to lower the tire pressure.

A. Right

B. Wrong

Answer: B

4. When a tire blowout on the road, the driver should swiftly depress the brake pedal to reduce speed and stop the vehicle.

A. Right

B. Wrong

Answer: B

5. What is the meaning of this sign?

A. Intersection

B. Ring intersection

C. T-shaped intersection

D. Y-shaped intersection

Answer: A

6. What is the meaning of this sign?

A. Downhill section on right side

B. Driving by the right side of the road

C. Stopping by the right side of the road

D. Right turn only

Answer: B

7. What is the meaning of this sign?

A. Road narrows on both sides

B. Road narrows on the right side

C. Road narrows on the left side

D. Bridge narrows

Answer: C

8. When a wounded person is under the wheel or cargo, the wrong method is to pull the limbs of the wounded.

A. Right

B. Wrong

Answer: B

9. May speed up to go through the crosswalk when no one is near it

A. Right

B. Wrong

Answer: B

10. The main impact of muddy roads on safe driving is that the wheels may easily spin and skid

A. Right

B. Wrong

Answer: A

11. What should motor vehicle drivers do when approaching an oncoming vehicle on a frozen road?

A. Cut speed as approaching each other

B. Pass each other by speeding up properly

C. Pass each other slowly by cutting speed in advance

D. Pass each other along the central line to the best

Answer: C

12. How should the driver pass this place safely?

A. Speed up and pass in the front of the pedestrians

B. Bypass behind the pedestrians

C. Slow down and sound the horn

D. Stop and wait until the pedestrians pass

Answer: D

13. When passing a sharp curve, motor vehicle drivers may overtake if there are few other vehicles on the road.

A. Right

B. Wrong

Answer: B

14. What is the meaning of this sign?

A. Going straight and right turn

B. Going straight and left turn

C. No going straight and no left turn

D. Right turn and left turn only

Answer: B

15. After a tire blows out and before the driver can control the speed of the vehicle, he should refrain from using the foot brake to stop the vehicle. Otherwise, a horizontal swing of the vehicle can cause greater danger.

A. Right

B. Wrong

Answer: A

16. Which measures is correct when a motor vehicle turn around?

A. Turn around in the turning lane

B. Should not turn on the turning light

C. Turn around in the straight lane

D. Turn on the left-turn signal in advance

Answer: AD

17. When driving into the traffic flow on a main road from a relief road, drivers should speed up.

A. Right

B. Wrong

Answer: B

18. When a motorcycle turns at an excessively high speed, it can easily dash out of a curve or skid sideways.

A. Right

B. Wrong

Answer: A

19. When a motorcycle is making a turn in a high speed, the driver should avoid using the brake or use the brake less to prevent sideslip.

A. Right

B. Wrong

Answer: A

20. When driving a motorcycle, the driver may wear slippers for the sake of safety.

A. Right

B. Wrong

Answer: B

21. When rescuing a wounded person who has been poisoned by toxic gas, the first measure is to send him to a place where air is fresh so that he will not continue to be poisoned.

A. Right

B. Wrong

Answer: A

22. People who take a two-wheeled motorcycle should ride it by side way.

A. Right

B. Wrong

Answer: B

23. Which lamp should be used when motor vehicles pass hrough an intersection at night where there is no traffic light signal?

A. High-beam

B. Low-beam

C. Hazard lamps

D. High-beam and low-beam should be used alternatively

Answer: D

24. Whats the meaning of the white horizontal solid line in the circle?

A. Turning waiting line

B. Deceleration line

C. Yielding line

D. Stop line

Answer: D

25. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D