齐齐哈尔摩托车科目四题库英文

1. When the vehicles cross each other at night, what should the driver do if the vehicle coming in the opposite direction don’t turn off the high beam light?

A. Reduce speed for yield or stop on the right side.

B. Continuous change lights to remind the vehicle coming in the opposite direction

C. Turn on the high lights and force the coming car to change the lights

D. Move his sight to the right side to evade the light

Answer: ABC

2. Speeding up to go though the intersection before the light turns to red in this case.

A. Right

B. Wrong

Answer: B

3. When driving a motorcycle, the driver may wear slippers for the sake of safety.

A. Right

B. Wrong

Answer: B

4. How will the adhesive force of road change when speed increases on a damp and slippery road?

A. Increase sharply

B. Increase gradually

C. Decrease sharply

D. No change

Answer: C

5. When a motor vehicle temporarily stops at night, which lamp should be turned on?

A. Front and rear fog lamp, clearance lamp and rear position lamp

B. Head lamp, clearance lamp and rear position lamp

C. Hazard lamp, clearance lamp and rear position lamp

D. Reverse lamp, clearance lamp and rear position lamp

Answer: C

6. It is not a bad habit for a driver to frequently change lanes.

A. Right

B. Wrong

Answer: B

7. Which lamp should be turned on when motor vehicles pass through a road section at night where the street light condition is good?

A. Front and rear fog lamps

B. Low-beam

C. High-beam

D. Hazard lamp

Answer: B

8. Serious wave will appear when the front tire blows out; the driver should release the accelerator, firmly hold the steering wheel with both hands, quickly gradually break down, and stop to yield.

A. Right

B. Wrong

Answer: A

9. When the engine suddenly stalls on the road, what should the driver do?

A. Stop the vehicle and overhaul it immediately

B. Immediately turn on the hazard lamps

C. Move the vehicle to a place where it will not obstruct the traffic flow

D. Set up a breakdown warning sign

Answer: BCD

10. It is illegal to change lanes without turning on indicators.

A. Right

B. Wrong

Answer: A

11. What is the meaning of this sign?

A. Steep downhill road

B. Continuous up slopes

C. Steep uphill road

D. Embankment road

Answer: C

12. When driving on a road covered with ice and snow, drivers tend to encounter glare caused by reflection of light rays from the road surface.

A. Right

B. Wrong

Answer: A

13. What is the meaning of this sign?

A. Slippery section

B. Sharp curve

C. Inverse curve

D. Continuous curves

Answer: C

14. When a vehicle stops temporarily at the roadside at night, the wrong measure is to ______.

A. Turn on the warning flash light

B. Turn on the contour light

C. Turn on the high beam light

D. Turn off all lights

Answer: CD

15. What is the meaning of this sign?

A. Reduce speed and go slowly

B. Watch for danger

C. Jammed section

D. Accident-prone section

Answer: B

16. When driving on a foggy day, the driver should turn on the fog lamp.

A. Right

B. Wrong

Answer: A

17. When driving, the driver should yield to _______.

A. Ambulance

B. Fire engine

C. School bus

D. Police car

Answer: ABCD

18. A driver should accelerate in advance to overtake then it is likely to meet with oncoming vehicles.

A. Right

B. Wrong

Answer: B

19. You can make an U turn at this intersection.

A. Right

B. Wrong

Answer: B

20. In which of the following ways can motor vehicles avoid a tire burst?

A. Lowering tire pressure

B. Checking tires regularly

C. Removing foreign matters from the tire tread grooves timely

D. Replacing the tires that have cracks or deep cuts

Answer: BCD

21. What is the meaning of this sign?

A. No U turn at intersection

B. No changing lane from both sides

C. No left or right turn

D. No going straight

Answer: C

22. When driving a motor vehicle into a traffic flow, drivers should not hold up other vehicles.

A. Right

B. Wrong

Answer: A

23. The motor vehicle should speed up and pass rapidly under this situation.

A. Right

B. Wrong

Answer: B

24. Gun powder, explosives and detonating powder belong to which of the following dangerous chemicals?

A. Oxidizing materials

B. Inflammable solid materials

C. Explosives

D. Self-igniting articles

Answer: C

25. When encountering non-motorized vehicles cutting in on the road, the driver should________.

A. Honk to warn

B. Speed up and bypass from the front

C. Voluntarily reduce speed and yield

D. Suddenly speed up when approaching

Answer: C