伊春摩托车科目四英语试题

1. What is the meaning of this sign?

A. No right turn

B. No U turn

C. No going straight

D. No left turn

Answer: C

2. When a motor vehicle moves through water, the driver should try to maintain a constant speed and sufficient power and pass through without stopping.

A. Right

B. Wrong

Answer: A

3. What is the meaning of this sign?

A. Road narrows on the left side

B. Narrow bridge

C. Narrow road

D. Road narrows on the right side

Answer: B

4. What is the meaning of this sign?

A. Hump bridge

B. High outburst road

C. Low-lying road

D. Bump road

Answer: A

5. What is the meaning of this sign?

A. Road narrows on both sides

B. Road narrows on the right side

C. Road narrows on the left side

D. Bridge narrows

Answer: C

6. A correct measure to avoid tire burst of motor vehicles is to lower the tire pressure.

A. Right

B. Wrong

Answer: B

7. When seeing this sign, the driver should reduce speed and observe the road conditions.

A. Right

B. Wrong

Answer: A

8. While driving a motorcycle, it is permitted to keep one hand on the handlebar but not allowed two hands leave handle bars at the same time.

A. Right

B. Wrong

Answer: B

9. When finding a tire burst on the road, the driver should gently depress the brake pedal, reduce speed and stop the vehicle slowly.

A. Right

B. Wrong

Answer: A

10. When driving on a damp and slippery road, drivers should avoid using the emergency brake to his/her best ability.

A. Right

B. Wrong

Answer: A

11. Turning on the high-beam is an effective way to improve visibility in fog weather.

A. Right

B. Wrong

Answer: B

12. When a motorcycle is making a turn in a high speed, the driver should avoid using the brake or use the brake less to prevent sideslip.

A. Right

B. Wrong

Answer: A

13. When a motor vehicle temporarily stops in fog, which lamp should be turned on?

A. Hazard lamp, clearance lamp and rear position lamp

B. Left-turn indicator, clearance lamp and rear position amp

C. Headlamp, clearance lamp and rear position lamp

D. Reverse lamp, clearance lamp and rear position lamp

Answer: A

14. When a motor vehicle temporarily stops at night, which lamp should be turned on?

A. Front and rear fog lamp, clearance lamp and rear position lamp

B. Head lamp, clearance lamp and rear position lamp

C. Hazard lamp, clearance lamp and rear position lamp

D. Reverse lamp, clearance lamp and rear position lamp

Answer: C

15. Which is the wrong measure to avoid tire burst?

A. Reduce tire pressure

B. Check tires regularly

C. Remove foreign matters from the tire tread grooves timely

D. Replace tires that have cracks or deep cuts

Answer: A

16. The article that cannot be used to stop bleeding by dressing is _________.

A. Bondage

B. Sling

C. Tourniquet

D. Hemp rope

Answer: D

17. Dangerous chemicals possess the characteristics of explosion, inflammation, poison, erosion and radiation.

A. Right

B. Wrong

Answer: A

18. Whats the meaning of this sign?

A. Pass with low speed

B. Watch for pedestrians

C. On foot

D. Pedestrians go first

Answer: C

19. Which lamp should be used when motor vehicles pass hrough an intersection at night where there is no traffic light signal?

A. High-beam

B. Low-beam

C. Hazard lamps

D. High-beam and low-beam should be used alternatively

Answer: D

20. What is the meaning of this sign?

A. Reducing speed 40m ahead

B. Minimum speed is 40km/hr

C. Axle weight limit is 40 tons

D. Maximum speed limit is 40km/hr

Answer: D

21. Motor vehicle drivers don’t need to use any lamp at night when passing through a road section where the street light condition is good.

A. Right

B. Wrong

Answer: B

22. What is the most frequent problem for driving on a muddy road?

A. High resistance force

B. Sideways slide

C. The motor vehicle bumps

D. Steering failure

Answer: B

23. Which measures is correct when a motor vehicle intends to overtake

A. Use the high and low beam lights alternately to indicate the intention

B. Honk to indicate the vehicle

C. Speed up and overtake on the right side

D. Turn on the left-turn signal in advance

Answer: ABD

24. After a traffic accident, what is the most effective measure to prevent secondary accidents?

A. Evacuate all passengers

B. Turn on the hazard lamps

C. Mark the original place of the injured persons

D. Properly place the danger warning sign

Answer: ABD

25. When a vehicle stops temporarily at the roadside at night, the wrong measure is to ______.

A. Turn on the warning flash light

B. Turn on the contour light

C. Turn on the high beam light

D. Turn off all lights

Answer: CD