宿迁摩托车科目四英文题库

1. In which of the following ways can motor vehicles avoid a tire burst?

A. Lowering tire pressure

B. Checking tires regularly

C. Removing foreign matters from the tire tread grooves timely

D. Replacing the tires that have cracks or deep cuts

Answer: BCD

2. When an erosive material catches fire, it should not be put out with water cannon.

A. Right

B. Wrong

Answer: A

3. How to reduce speed or stop when driving on a road covered with snow and ice?

A. Take full advantage of driving brake

B. Take full advantage of the control power from engine

C. Take full advantage of parking brake

D. Take full advantage of speed retarder

Answer: B

4. Keep enough safe distance When a motor vehicle follows another vehicle, because ______.

A. Avoke a rear-end collision

B. The closer you get to the vehicle, the less easy it is to grasp the situation ahead of the vehicle.

C. Enough distance to avoid emergencies

D. Prevent being unable to detect the front vehicle brake in time due to the damage rear lamp of the front vehicle

Answer: ABCD

5. There is a risk of overtaking when driving a motor vehicle approaches the top of the slope on a mountainous road, because _____.

A. When approaching the top of the slope, the line of sight is blocked and it is impossible to observe the traffic situation.

B. When approaching the top of the slope, the line of sight is blocked. It is impossible to observe whether there are obstacles behind the top of the slope.

C. The speed is slower when approaching the top of the slope.

D. When approaching the top of the slope, the line of sight is blocked and the road direction behind the top of the slope can not be observed.

Answer: ABD

6. When passing a turn or a curve section, the driver should slow down and disengage the clutch.

A. Right

B. Wrong

Answer: B

7. Under such circumstances, motor vehicle drivers should bypass on the left quickly.

A. Right

B. Wrong

Answer: B

8. When a motor vehicle passes over an overflowing bridge, what should the driver do after stopping and observing closely?

A. Change to a high gear and pass rapidly

B. Constantly observe the changes of the flow

C. Prepare to stop at any time

D. Change to a low gear and pass through at a constant speed

Answer: D

9. What are the driving behaviors that cause accidents when a motor vehicle turns to a turning road?

A. Vehicles occupy opposite lanes

B. Turn the steering wheel sharply in the bend

C. Do not slow down before turning

D. Motor vehicles drive on the right side of the road

Answer: ABC

10. What is the meaning of this sign?

A. Crosswalk

B. Students’ passage

C. Watch for pedestrians

D. Children’s passage

Answer: A

11. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D

12. A light motorcycle is only permitted to carry preschoolers.

A. Right

B. Wrong

Answer: B

13. What is the meaning of this sign?

A. U turn

B. Reversing

C. Left turn

D. Bypassing

Answer: A

14. What is the meaning of this sign?

A. Stop to yield

B. No stopping temporarily

C. No entry

D. No long stopping

Answer: A

15. A driver should accelerate in advance to overtake then it is likely to meet with oncoming vehicles.

A. Right

B. Wrong

Answer: B

16. When driving a motor vehicle near an intersection, the vehicle may speed up and honk to pass.

A. Right

B. Wrong

Answer: B

17. Which one of the following measures is correct when a motor vehicle intends to overtake but the vehicle infront refuses to yield?

A. Use a long-sounding horn

B. Follow the vehicle in front while turning high-beam

C. Wait for it to yield while keeping a safe distance

D. Use high-beam and low-beam alternatively

Answer: C

18. When a vehicle stops temporarily at the roadside at night, the wrong measure is to ______.

A. Turn on the warning flash light

B. Turn on the contour light

C. Turn on the high beam light

D. Turn off all lights

Answer: CD

19. Before driving, it is necessary to check whether the cooling liquid, engine oil and fuel oil, are leaking.

A. Right

B. Wrong

Answer: A

20. Which measures is correct when a motor vehicle intends to overtake

A. Use the high and low beam lights alternately to indicate the intention

B. Honk to indicate the vehicle

C. Speed up and overtake on the right side

D. Turn on the left-turn signal in advance

Answer: ABD

21. What is the meaning of this sign?

A. Reducing speed 40m ahead

B. Minimum speed is 40km/hr

C. Axle weight limit is 40 tons

D. Maximum speed limit is 40km/hr

Answer: D

22. When passing through a tunnel, the wrong measure is to ___________.

A. Keep safe distance when two vehicles cross each other

B. Driving with the low beam light

C. Use the hight beam light when two vehicles cross each other

D. Overtaking in the tunnel

Answer: CD

23. Whats the meaning of this mark on the road?

A. The lane for non-motorized vehicles

B. The special lane for motorcycles

C. The special lane for battery bicycles

D. the special lane for bicycles

Answer: A

24. What are the main reason for slow driving of motorized vehicles on rainy days?

A. Braking distance will increase

B. The driver’s view islimited

C. Emergency braking can easily cause side skidding

D. Fast driving increases fuel consumption

Answer: ABC

25. The drivers, loaders and supercargoes responsible for dangerous chemicals transportation should all full understand the chemical characteristics, potential risks, features of the packaging containers and emergency measures for any unexpected accidents.

A. Right

B. Wrong

Answer: A