鹰潭摩托车科目一考试英文400题

1. When a motor vehicle temporarily stops in fog, which lamp should be turned on?

A. Hazard lamp, clearance lamp and rear position lamp

B. Left-turn indicator, clearance lamp and rear position amp

C. Headlamp, clearance lamp and rear position lamp

D. Reverse lamp, clearance lamp and rear position lamp

Answer: A

2. What is the meaning of this sign?

A. no U turn at intersection

B. no changing lane from both sides

C. no left or right turn

D. no going straight

Answer: C

3. Driving a motorized vehicle on the road in violation of road traffic regulations shall be subject to relevant punishment.

A. Right

B. Wrong

Answer: A

4. How to drive through the intersection without traffic lights?

A. reduce speed and go slowly

B. speed up and pass

C. let large vehicle go first

D. let the left vehicle go first

Answer: A

5. When a motorcycle is making a turn in a high speed, the driver should avoid using the brake or use the brake less to prevent sideslip.

A. Right

B. Wrong

Answer: A

6. When a motorcycle wades across the water, the braking efficiency of the brake does not change.

A. Right

B. Wrong

Answer: B

7. What is the meaning of this sign?

A. U turn

B. reversing

C. left turn

D. bypassing

Answer: A

8. Violent wind can cause a sideways swerve to a running vehicle.

A. Right

B. Wrong

Answer: A

9. When passing a turn or a curve section, the driver should slow down and disengage the clutch.

A. Right

B. Wrong

Answer: B

10. When evading an emergency, except for being calm what principle should be held by drivers?

A. Evading people first and then objects

B. Evading objects first and then vehicles

C. Evading vehicles first and then people

D. Evading objects first and then people

Answer: A

11. What is the meaning of this sign?

A. driving at reduced speed in the section of 40 meters

B. minimum speed is 40km/hr

C. maximum speed is 40km/hr

D. 40km/hr speed limit ban is lifted

Answer: D

12. When crossing each other at night, how far should change the high beam lights to low beam lights?

A. not need to change lights

B. beyond 150m

C. within 100m

D. within 50m

Answer: B

13. Which is correct when riding a motorcycle

A. Both hands can temporarily leave the steering handle bar

B. Voluntarily operate the steering handle bar

C. It is prohibited to simultaneously move two hands from the steering handle bar

D. It is able to statically turn the steering handle bar

Answer: C

14. When a tire blowout on the road, the driver should control the direction of the vehicle and use emergency braking to bring the vehicle swiftly to a stop.

A. Right

B. Wrong

Answer: B

15. The width of loaded goods should ______________ from a three-wheel motorcycle.

A. not exceed 0.15 meter

B. not exceed

C. not exceed 0.20 meter

D. not exceed 0.25 meter

Answer: B

16. Traffic Police can detain the vehicle according to law if the driver does not carry the ID card.

A. Right

B. Wrong

Answer: B

17. What is the meaning of this sign?

A. road narrows on the left side

B. narrow bridge

C. narrow road

D. road narrows on the right side

Answer: B

18. What is the meaning of this sign?

A. bump road

B. low-lying road

C. high outburst road

D. hump bridge

Answer: B

19. A correct measure to avoid tire burst of motor vehicles is to lower the tire pressure.

A. Right

B. Wrong

Answer: B

20. When driving on a damp and slippery road, drivers should avoid using the emergency brake to his/her best ability.

A. Right

B. Wrong

Answer: A

21. A motorized vehicle driver who uses other motorized vehicle’s license plate and vehicle license is subject to a 3-point penalty.

A. Right

B. Wrong

Answer: B

22. When driving on a rough road, the driver should use low gear to keep low speed; try to choose roads with big pits to reduce bumpy feeling.

A. Right

B. Wrong

Answer: B

23. It is an illegal act for the driver to make calls while driving.

A. Right

B. Wrong

Answer: A

24. Which shoud be taken along while driving?

A. vocational qualification certificate

B. ID card

C. driving license

D. work permits

Answer: C

25. What should motor vehicle drivers do when approaching an oncoming vehicle on a frozen road?

A. Cut speed as approaching each other

B. Pass each other by speeding up properly

C. Pass each other slowly by cutting speed in advance

D. Pass each other along the central line to the best

Answer: C