鄂尔多斯外国人考摩托车驾照

1. When the road maintenance vehicle and the engineering vehicle are on duty, the passing vehicles should avoid with care.

A. Right

B. Wrong

Answer: A

2. How to pass through the unmanned level crossing without traffic lights?

A. properly reduce speed to pass

B. slide over in the neutral gear

C. stop to make sure it is safe, then pass

D. speed up and pass as fast as possible

Answer: C

3. If a motorized vehicle causes a traffic accident on the road, the driver should immediately move the vehicle to the roadside.

A. Right

B. Wrong

Answer: B

4. Traffic lights are divided into red, green and yellow light.

A. Right

B. Wrong

Answer: A

5. Driving a motorized vehicle shall not overtake in tunnels, steep slopes and other special sections.

A. Right

B. Wrong

Answer: A

6. When driving on road sections where safe sight distance is affected, such as the top of a ramp, what should drivers do to ensure safety?

A. Rush through

B. Use hazard lamp

C. Cut speed and sound the horn

D. Drive at will

Answer: C

7. It is not safe for a female driver to wear high heels to drive a vehicle.

A. Right

B. Wrong

Answer: A

8. How to use lights when pulling over on road?

A. turn on the hazard lights

B. turn on the right-turn signal in advance

C. use the high and low beam lights alternately

D. not need to use any light to indicate

Answer: B

9. In which situation that a driver cannot drive?

A. after drinking coffee

B. after drinking milk

C. after drinking

D. after drinking tea

Answer: C

10. When a motorcycle braking on a road covered by ice and snow, the driver should adopt point braking and prepare their feet for landing when braking.

A. Right

B. Wrong

Answer: A

11. When a traffic accident causing human injuries, preserve the scene and immediately report to the police.

A. Right

B. Wrong

Answer: A

12. When a motorized vehicle passes through narrow road or bridge, the maximum speed should not exceed 30 kilometers per hour.

A. Right

B. Wrong

Answer: A

13. What is the meaning of this sign?

A. no going straight and no changing to left lane

B. no going straight and no left turn

C. allowed to go straight and turn left

D. no going straight and no right turn

Answer: B

14. When a motorcycle passing through an interchange discovers it has chosen a wrong route, it should immediately make a U turn from where it is or reverse to change route.

A. Right

B. Wrong

Answer: B

15. When driving a motorcycle, the driver may wear slippers for the sake of safety.

A. Right

B. Wrong

Answer: B

16. What is the meaning of this sign?

A. passing by the right side

B. passing by the left side

C. running to right side

D. running the roundabout

Answer: D

17. How will the adhesive force of road change when speed increases on a damp and slippery road?

A. Increase sharply

B. increase gradually

C. decrease sharply

D. No change

Answer: C

18. When passing an intersection without traffic lights, the driver should go through as fast as possible.

A. Right

B. Wrong

Answer: B

19. A person who has not obtained driving license drives a motorized vehicle, he will be held for legal liability.

A. Right

B. Wrong

Answer: A

20. If a motorized vehicle driver has caused a major accident in violation of the traffic regulations which has caused serious injury, the driver is subject to a prison term of less than 3 years or a criminal detention.

A. Right

B. Wrong

Answer: A

21. A motorcycle is not permitted to tow other vehicles or to be towed by other vehicles.

A. Right

B. Wrong

Answer: A

22. In which section cannot overtake?

A. mountain road

B. urban elevated road

C. urban expressway

D. narrow bridge and curve

Answer: D

23. You may not use the turn signal when you change to the right lane.

A. Right

B. Wrong

Answer: B

24. What is the meaning of this sign?

A. bump road

B. high outburst road

C. low-lying road

D. hump bridge

Answer: B

25. Which lamp should be used when motor vehicles pass hrough an intersection at night where there is no traffic light signal?

A. High-beam

B. Low-beam

C. Hazard lamps

D. High-beam and low-beam should be used alternatively

Answer: D