娄底驾照英文对照

1. This sign reminds the width of the bridge narrows ahead.

A. Right

B. Wrong

Answer: B

2. How to do when encountering slow-moving vehicles in front?

A. follow the vehicles in front

B. occupy the opposite lane to overtake

C. borrow the lane from right side to overtake

D. overtake from both sides as will

Answer: A

3. If one drives an illegally assembled motorized vehicle, he should not only pay the fine, but also ________ .

A. be confiscated the driving license

B. be revoked the driving permission

C. be forced to recover the vehicle condition

D. be revoked the driving license

Answer: D

4. What kind of violation does this stopping car have?

A. stop occupying the lane for non-motorized vehicles

B. stop in the section with no stopping marking

C. stop at bus station

D. stop occupying sidewalk

Answer: C

5. When a vehicle runs on an expressway, the driver may ascertain the speed according to his feeling.

A. Right

B. Wrong

Answer: B

6. After starting the engine, it lights to indicate that ______

A. fuel pump abnormal or malfunction

B. ignition system malfunction

C. fuel supply system is abnormal

D. fuel in tank reaches the minimum level

Answer: D

7. Whats the meaning of this sign?

A. distance to a tourist area

B. category of a tourist area

C. direction of a tourist area

D. symbol of a tourist area

Answer: C

8. The full mark of Driving Skills, Common Knowledge on Safe and Courteous Driving of the subject 3 test is 100, each of the passing mark is 80 and 90.

A. Right

B. Wrong

Answer: B

9. This sign warns two neighboring inverse curves ahead.

A. Right

B. Wrong

Answer: B

10. It lights to indicate that the generator is charging to the batteries.

A. Right

B. Wrong

Answer: B

11. It lights when turning on the width light.

A. Right

B. Wrong

Answer: A

12. What marking is the white solid lines in the circle?

A. guide lanes lines

B. variable guide lanes lines

C. direction guide lines

D. one-way driving lines

Answer: A

13. Whats the meaning of this sign?

A. minimum speed limit is 50km/hr

B. maximum speed limit is 50km/hr

C. the height is 50m

D. the altitude is 50m

Answer: A

14. Which part does it control when pulling this switch?

A. turn signals

B. reverse light

C. contour light

D. hazard light

Answer: A

15. The driving license of a motorized vehicle driver will be detained after his penalty scores reach 12 points in a scoring circle.

A. Right

B. Wrong

Answer: A

16. What is this traffic sign?

A. Road narrows on both sides

B. Road narrows on the right side

C. Road narrows on the left side

D. Bridge narrows

Answer: B

17. When a driver drives a motorized vehicle during the period of probation, the driver should paste or hang a uniform probation mark on the rear part of the vehicle.

A. Right

B. Wrong

Answer: A

18. When a vehicle enters a two-way tunnel, the driver should turn on ________.

A. The hazard lights

B. The high beam light

C. The fog light

D. The width light or the low beam light

Answer: D

19. Whats the meaning of this sign?

A. no U turn at intersection

B. no changing lane from both sides

C. no left or right turn

D. no going straight

Answer: C

20. Whats the meaning of this sign?

A. intersection

B. ring intersection

C. T-shaped intersection

D. Y-shaped intersection

Answer: A

21. What causes the rear-end collision?

A. not observe through the rear-view mirror while the vehicle in front brakes

B. the vehicle in front brakes suddenly

C. distance from the vehicle in front is too close when the rear vehicle overtakes

D. not maintain a safe distance from the vehicle in front

Answer: D

22. Traffic markings are divided into indication, warning and prohibition.

A. Right

B. Wrong

Answer: A

23. When driving slowly in a congested road, the driver should ________ if another vehicle forcefully cuts in.

A. Honk to warn it against cutting in

B. Speed up to closely follow the vehicle in front and refuse to allow it to cut in

C. Squeeze the cutting-in vehicle to force it to leave

D. Voluntarily yield to ensure safe driving

Answer: D

24. When a vehicle changes lane, the driver should turn on the turn signal in advance,observe traffic conditions, maintain a safe distance and move into the new lane.

A. Right

B. Wrong

Answer: A

25. When a vehicle on the main road approaches a conjunction with a feeder road, the driver should ______ in order to prevent a collision with a vehicle that suddenly enters from the feeder road.

A. Maintain the normal speed

B. Reduce speed in advance, observe and drive with care

C. Honk and swiftly pass

D. Speed up in advance and pass

Answer: B