东莞交通法规英文交规题库

1. The main impact of the road conditions at night on safe driving is ________.

A. The visibility is low and unfavorable for observing road traffic conditions

B. The road surface is complex and changing

C. The physical strength of the driver decreases

D. The driver can easily have impulse and illusion

Answer: A

2. In which situation cannot overtake a vehicle in front?

A. vehicle in front is reducing speed to yield

B. vehicle in front is turning left

C. vehicle in front is pulling over by the roadside

D. vehicle in front is turning right

Answer: B

3. Whats the meaning of this figure mark on the road?

A. a mark of keeping distance

B. a mark of minimum distance

C. a mark of speed limit

D. a mark of road number

Answer: C

4. This sign warns obstacles ahead and reducing speed to bypass.

A. Right

B. Wrong

Answer: B

5. When driving at night, the drivers observation ability is visibly poorer and his visibility range becomes shorter than driving in the daytime.

A. Right

B. Wrong

Answer: A

6. This set of the hand signals of the traffic police indicates that the vehicles should ___ .

A. go straight

B. make a turn

C. stop

D. pull over

Answer: A

7. When the driver discovers a tire is leaking and steers the vehicle off the main carriageway, he should refrain from applying emergency so as to avoid a vehicle turnover or a rear-end collision arising from the late braking of the following vehicle.

A. Right

B. Wrong

Answer: A

8. What device does the switch of this symbol control?

A. the windscreen wiper and washer

B. the rear window defrosting or defogging

C. the rear window wiper and washer

D. the windscreen defrosting or defogging

Answer: C

9. What marking is the combination of the white broken lines and the triangle area?

A. road entry marking

B. lane-dividing line that can be crossed

C. deceleration line at road entry

D. road exit marking

Answer: A

10. Opening the doors of a motorized vehicle should not obstruct the flow of other vehicles and pedestrians.

A. Right

B. Wrong

Answer: A

11. Driving a small passenger vehicle on the expressway, the minimum speed should not be less than 90 kilometers per hour.

A. Right

B. Wrong

Answer: B

12. Which part does it control when rotating this part of the switch?

A. the low beam lights

B. the head and tail fog lights

C. high beam lights

D. turn signals

Answer: B

13. Driving on the expressway with full signs and marking, the driver should run in the lane and at the speed according to _________.

A. Signs and markings

B. Rules on road traffic safety

C. Vehicle manual

D. Local regulations

Answer: A

14. What mark is the inclined yellow and black lines?

A. entity mark

B. protrusions mark

C. three-dimensional mark

D. deceleration mark

Answer: C

15. It lights to indicate that ______

A. left-turn signal flashes

B. front and rear width lights light on

C. front and rear width lights light on

D. right-turn signal flashes

Answer: A

16. The yellow lane-dividing line on the road is used to _____

A. allow to drive in left lane

B. separate the traffic flow in opposite directions

C. separate the traffic flow in the same direction

D. prohibit to cross the opposite lane

Answer: B

17. What is this manipulation device?

A. the handbrake

B. the air throttle lever

C. the gear lever

D. the clutch lever

Answer: C

18. The driving license of a motorized vehicle driver will be detained after his penalty scores reach 12 points in a scoring circle.

A. Right

B. Wrong

Answer: A

19. Whats the meaning of this sign?

A. no stopping temporarily

B. no long stopping

C. no stopping

D. long stopping is allowed

Answer: B

20. Whats the meaning of this sign?

A. watch for long time honking

B. an unmanned level crossing

C. a manned level crossing

D. multi-crossing of railway and road

Answer: B

21. 7.When a vehicle changes lane before an intersection, the driver should do so ______.

A. In the area marked by solid lines before the intersection

B. In the area marked by solid lines in the intersection

C. In the area marked by broken lines as indicated by the guide arrow

D. Before the stop line at the intersection

Answer: C

22. Whats the meaning of the white solid lines at the edge of the carriageway on both sides of the road?

A. Vehicles may cross temporarily

B. Vehicles are not allowed to cross.

C. Motorized vehicles may cross temporarily.

D. Non-motorized vehicles may cross temporarily

Answer: B

23. What marking is the road mark?

A. crosswalk ahead

B. intersection ahead

C. reduce speed and yield ahead

D. stop to yield ahead

Answer: A

24. Whats the meaning of this sign?

A. expressway right side exit ahead

B. expressway next exit indication

C. expressway location and direction indication

D. expressway left side exit ahead

Answer: C

25. This sign indicates obstacle ahead and bypassing from left side.

A. Right

B. Wrong

Answer: A