吉安英文版驾校考试科目一

1. When a vehicle runs on an expressway at the speed of 100 kilometers per hour, its safe distance from the vehicle in front is not less than 100 meters.

A. Right

B. Wrong

Answer: A

2. Speed up when passing the overflowing road.

A. Right

B. Wrong

Answer: B

3. This sign warns obstacles ahead and reducing speed to bypass.

A. Right

B. Wrong

Answer: B

4. When a motorized vehicle runs on an expressway, it ________.

A. May stop on the road shoulder to let passengers on and off

B. May stop in the emergency lane to load and unload cargos

C. May overtake or stop in the acceleration or deceleration lane

D. Is not allowed to drive or stop in the emergency lane in a non-emergency case

Answer: D

5. How to run if this traffic light continuously flashes?

A. speed up and pass as soon as possible

B. stop by the side to wait

C. look and make sure it is safe to pass

D. apply emergency braking

Answer: C

6. When ignition switch is in the START position, the starter starts.

A. Right

B. Wrong

Answer: A

7. A driver may drive a motorized vehicle after the driving license has been lost within 3 months.

A. Right

B. Wrong

Answer: B

8. This sign warns a sharp left curve ahead.

A. Right

B. Wrong

Answer: A

9. When a motorized vehicle breaks down on the road and is difficult to move, the driver should place a warning sign within 50 meters behind the vehicle.

A. Right

B. Wrong

Answer: B

10. Whats the meaning of this sign?

A. an unmanned level crossing 150m ahead

B. an unmanned level crossing 100m ahead

C. a manned level crossing 100m ahead

D. a manned level crossing 150m ahead

Answer: A

11. This sign reminds there is a one-way and poor lighting culvert ahead.

A. Right

B. Wrong

Answer: B

12. What is the max speed when passing a level crossing?

A. 15km/hr

B. 20km/hr

C. 30km/hr

D. 40km/hr

Answer: C

13. Whats the meaning of this sign?

A. low-lying road

B. hump bridge

C. bump road

D. high outburst road

Answer: C

14. Whats the meaning of the white markings on the road?

A. road construction marking

B. horizontal deceleration marking

C. vertical deceleration marking

D. fewer lanes indication marking

Answer: B

15. Whats the meaning of this sign?

A. distance to a tourist area

B. direction of a tourist area

C. symbol of a tourist area

D. category of a tourist area

Answer: A

16. This sign reminds there is a ferry ahead for vehicles.

A. Right

B. Wrong

Answer: A

17. When driving during the period of probation, the driver should paste or hang _____ on the rear part of the vehicle

A. a mark of avoiding with care

B. a mark of paying attention of beginner

C. a uniform probation mark

D. a mark of paying attention of vehicle distance

Answer: C

18. When the light switch is rotated to the position, the whole car lights turn on.

A. Right

B. Wrong

Answer: B

19. When changing lanes on an expressway, the driver should turn on the turn signal in advance, observe the traffic conditions, and slowly turn the steering wheel and enter the new lane after making sure it is safe to do so.

A. Right

B. Wrong

Answer: A

20. The main impact of mountain roads on safe driving is _______.

A. The traffic conditions are boring

B. The slopes are long, the curves are sharp and visibility range is shorter.

C. The traffic flow is heavy

D. The road signs are fewer

Answer: B

21. Whats the meaning of this sign?

A. going straight and left turn

B. going straight and right turn

C. no going straight and no right turn

D. left turn and right turn only

Answer: B

22. A motorized vehicle driver who drives after drinking is subject to a 12-point penalty.

A. Right

B. Wrong

Answer: A

23. When a motorized vehicle breaks down at night, and is difficult to move, the driver should turn on the hazard lights, the contour lights and the tail lights.

A. Right

B. Wrong

Answer: A

24. This sign indicates construction section ahead and bypassing from left or right side.

A. Right

B. Wrong

Answer: B

25. How to use lights when pulling over on road?

A. turn on the hazard lights

B. turn on the right-turn signal in advance

C. use the high and low beam lights alternately

D. not need to use any light to indicate

Answer: B