宁夏摩托车英文题库PDF电子版

1. The marking on the road surface indicates that the speed limit of this road section is 80 km/hour.

A. Right

B. Wrong

Answer: B

2. In rain, the most effective way to avoid the danger arising from water slide is to drive at high speed

A. Right

B. Wrong

Answer: B

3. How to reduce speed or stop when driving on a road covered with snow and ice?

A. Take full advantage of driving brake

B. Take full advantage of the control power from engine

C. Take full advantage of parking brake

D. Take full advantage of speed retarder

Answer: B

4. If a motor vehicle misses an exit on the expressway, the driver may reverse along the road shoulder.

A. Right

B. Wrong

Answer: B

5. The sign on the right indicates a bypass route at the intersection ahead.

A. Right

B. Wrong

Answer: A

6. Drivers may go straight and pass through when trafficpolice give these hand signals

A. Right

B. Wrong

Answer: B

7. When going straight or turning right, drivers are not allowed to drive on or across the guide lines on both sides of the intersection.

A. Right

B. Wrong

Answer: A

8. What should the driver do upon finding a burst rear tire?

A. Adjust by swiftly turning the steering wheel

B. Control the direction while reducing speed slowly

C. Swiftly turn the steering wheel to the opposite direction

D. Swiftly take braking measures

Answer: B

9. The sign on the right warns of a narrowed road on both sides ahead.

A. Right

B. Wrong

Answer: B

10. How many kinds of law-breaking acts are displayed in flash 6?

A. One

B. Two

C. Three

D. Four

Answer: C

11. When approaching motor vehicles ahead running at a normal speed on the highway, drivers behind may find a chance and weave through them swiftly.

A. Right

B. Wrong

Answer: B

12. Drivers are not allowed to cross these lane-dividing lines when overtaking in the same direction.

A. Right

B. Wrong

Answer: A

13. Which one of the following is the safest way when driving a motor vehicle on this road?

A. Speed up and bypass the obstacle

B. Take the opposite lane and compel the other vehicle to yield

C. Stop and yield to the oncoming vehicle

D. Sound the horn or turn on the headlamp

Answer: C

14. When the engine suddenly stalls on the road and cannot be restarted, the driver should apply emergency braking to force the vehicle to stop as fast as possible.

A. Right

B. Wrong

Answer: B

15. The sign on the right warns of right-hand S-shaped bend ahead.

A. Right

B. Wrong

Answer: B

16. Before setting off, it is necessary to check the driving cabin, engine cabin, external and tires of the motor vehicle.

A. Right

B. Wrong

Answer: A

17. How many kinds of law-breaking acts are displayed in flash 2?

A. One

B. Two

C. Three

D. Four

Answer: B

18. The stop-and-yield line at the intersection ahead indicates that vehicle drivers should reduce speed and give the right of way to vehicles on the trunk road.

A. Right

B. Wrong

Answer: B

19. Dangerous chemicals possess the characteristics of explosion, inflammation, poison, erosion and radiation.

A. Right

B. Wrong

Answer: A

20. On which of the following roads may the wheels be most easily locked when braking?

A. Concrete road

B. Dirt road

C. Road covered by ice and snow

D. Sand road

Answer: C

21. Motor vehicles are prohibited from stopping on the ramp of an expressway.

A. Right

B. Wrong

Answer: A

22. The sign in front indicates that vehicles except large passenger vehicles are not allowed to drive on the right lane.

A. Right

B. Wrong

Answer: B

23. The road marker indicates that vehicles are not allowed to make a U-turn at the intersection ahead.

A. Right

B. Wrong

Answer: A

24. What should the driver do when the motor vehicle passes a flyover?

A. Speed up and pass rapidly

B. Keep the speed under 15 km/hour

C. Drive at the speed indicated by the traffic sign

D. Drive close to the central line of the flyover

Answer: C

25. Matches, sulfur and red phosphorus belong to which of the following dangerous chemicals?

A. Explosives

B. Oxidizing materials

C. Self-igniting articles

D. Inflammable solid materials

Answer: D