安庆驾校一点通英文版

1. When entering an expressway toll gate, the driver should select a gate where _______.

A. There are more vehicles

B. The red light is on

C. The green light is on

D. Service is temporarily suspended

Answer: C

2. What is the max speed on the expressway when the visibility is lower than 200m?

A. less than 100km/hr

B. less than 90km/hr

C. less than 60km/hr

D. less than 80km/hr

Answer: C

3. It lights to indicate that ______

A. front and rear width lights light on

B. front and rear width lights light on

C. left-turn signal flashes

D. right-turn signal flashes

Answer: D

4. This sign indicates running slowly or stopping to let the vehicle on main road go first.

A. Right

B. Wrong

Answer: A

5. Whats the meaning of this sign?

A. low-lying road

B. hump bridge

C. bump road

D. high outburst road

Answer: C

6. One can drive the low-speed truck if the authorized vehicle applied for is small motor vehicle with automatic transmission.

A. Right

B. Wrong

Answer: B

7. When a vehicle goes downhill, it may fully use the neutral gear and slide.

A. Right

B. Wrong

Answer: B

8. When the green arrow for a lane is on and there are still pedestrians in the crosswalk before the vehicle, the driver should ___________.

A. Directly start up and pass

B. Start up and bypass the pedestrians from behind

C. Start up and bypass before the pedestrians

D. Start up after the pedestrians have passed

Answer: D

9. Whats the meaning of this sign?

A. no changing lane

B. no left turn

C. no going straight

D. no U turn

Answer: D

10. The vehicle can not run straight or turn left in this situation.

A. Right

B. Wrong

Answer: A

11. Whats the meaning of this sign?

A. bump road

B. high outburst road

C. low-lying road

D. hump bridge

Answer: B

12. What marking is the white solid lines in the circle?

A. guide lanes lines

B. variable guide lanes lines

C. direction guide lines

D. one-way driving lines

Answer: A

13. What marking is the combination of the white broken lines and the triangle area?

A. road entry marking

B. lane-dividing line that can be crossed

C. deceleration line at road exit

D. road exit marking

Answer: D

14. How to use lights when pulling over on road?

A. turn on the hazard lights

B. turn on the right-turn signal in advance

C. use the high and low beam lights alternately

D. not need to use any light to indicate

Answer: B

15. After starting the engine, it lights to indicate that ______

A. engine main oil way blockage

B. engine oil pressure is too low

C. engine crankshaft box leaks

D. engine oil pressure is too high

Answer: B

16. When finding a vehicle in the opposite direction having difficulty to go forward and needing to borrow road while crossing each other, the driver should ________.

A. Not occupy the road of the other side and should go forward normally

B. Indicate the other side to stop and yield

C. Speed up and go forward by the right side

D. Yield to the other side as much as possible

Answer: D

17. Whats the meaning of this sign?

A. no passing for small vehicle

B. passing for small vehicle only

C. passing for motorized vehicle

D. no passing for small vehicle

Answer: C

18. Max speed when pass the narrow road or bridge is _______

A. 50km/hr

B. 40km/hr

C. 30km/hr

D. 60km/hr

Answer: C

19. When a vehicles turns, it should do so on the right side and refrain from occupying the lane of the other party. The left turn should be gentle and the right turn should be sharp.

A. Right

B. Wrong

Answer: A

20. When passing a section of a mountain road which is prone to landside and mudflow, the driver should not stop.

A. Right

B. Wrong

Answer: A

21. Whats the meaning of this sign?

A. customs inspection

B. stop-for-inspection

C. frontier inspection

D. no passing

Answer: B

22. When a driver drives a motorized vehicle during the period of probation, the driver should paste or hang a uniform probation mark on the rear part of the vehicle.

A. Right

B. Wrong

Answer: A

23. Whats the meaning of this guide arrow?

A. left curve or need to merge with the left flow ahead

B. right curve or need to merge with the right flow ahead

C. merge with the left flow due to right side obstacle ahead

D. left curve or need to bypass from left side ahead

Answer: A

24. When driving at night on a road with no or poor lighting, the driver should switch from the low beam light to the high beam light. But the vehicle following in the same direction is not allowed to use the high beam light.

A. Right

B. Wrong

Answer: A

25. When driving in a foggy day, the driver should turn on ______.

A. The reverse light

B. The low beam light

C. The fog light

D. The high beam light

Answer: C