长沙英文考驾照用语

1. Turn on the left-turn signal in advance when making a U turn on the road.

A. Right

B. Wrong

Answer: A

2. Whats the meaning of the white rectangle marking?

A. special space for taxicabs to take and drop passengers

B. horizontal parking space

C. inclined parking space

D. vertical parking space

Answer: B

3. Whats the meaning of this sign?

A. watch for pedestrians

B. crosswalk

C. village or town

D. primary school

Answer: C

4. Whats the meaning of this sign?

A. T-shaped intersection ahead

B. road branching point ahead

C. Y-shaped intersection ahead

D. intersection ahead

Answer: A

5. What is this manipulation device?

A. switch of reverse light

B. switch of wiper

C. switch of the hazard lights

D. combination switch of lights and signals

Answer: D

6. A motorized vehicle driver who drives after drinking is subject to a ________.

A. 3-point penalty

B. 2-point penalty

C. 6-point penalty

D. 12-point penalty

Answer: D

7. Whats the meaning of this mark on the road?

A. average speed is 100km/hr

B. minimum speed limit is 100km/hr

C. 100km/hr speed limit ban is lifted

D. maximum speed limit is 100km/hr

Answer: D

8. How the front vehicle to run in this situation?

A. run as normal

B. yield

C. turn on the hazard lights

D. should not change lane

Answer: B

9. What is this manipulation device?

A. the handbrake

B. the air throttle lever

C. the gear lever

D. the clutch lever

Answer: C

10. This set of the hand signals of the traffic police indicates that the vehicles should ___ .

A. turn left

B. wait to turn left

C. reduce speed and pass slowly

D. turn right

Answer: B

11. If a motorized vehicle driver allows his vehicle to be driven by a person whose driving license has been revoked, the traffic police will detain the driving license.

A. Right

B. Wrong

Answer: A

12. What marking is the yellow broken line in the circle?

A. non-motorized vehicles guide lines

B. intersection guide line

C. lane connection lines

D. small vehicles turning lines

Answer: B

13. The starter works when turning the ignition switch to the ACC position.

A. Right

B. Wrong

Answer: B

14. When a motorized vehicle breaks down on the expressway, the driver should place a warning sign 50 meters ~ 100 meters in the coming direction.

A. Right

B. Wrong

Answer: B

15. This sign warns the driver there is a crosswalk ahead.

A. Right

B. Wrong

Answer: B

16. As thick fog reduces visibility, turning on the high beam light can increase the visibility.

A. Right

B. Wrong

Answer: B

17. The contents of subject 2 test for small motor vehicle include Reversing stall parking, stopping at the appointed position and setting off on a slope, pulling over, driving by S-shaped line, sharp turning.

A. Right

B. Wrong

Answer: A

18. Whats the meaning of this sign?

A. expressway right side exit ahead

B. expressway next exit indication

C. expressway location and direction indication

D. expressway left side exit ahead

Answer: C

19. When encountering non-motorized vehicles intending to bypass a stopping vehicle, the driver should ________.

A. Honk to indicate them to yield

B. Yield to them

C. Speed up and bypass

D. Follow them closely and honk

Answer: B

20. It displays the current engine speed is 6000 rev / min.

A. Right

B. Wrong

Answer: B

21. When driving at night on a road that has good lighting, the driver should use _______.

A. The fog light

B. The low beam light

C. The high beam light

D. The hazard lights

Answer: B

22. It lights when turning on the width light.

A. Right

B. Wrong

Answer: A

23. Driving license will be detained if you allow to drive your car.

A. driver during the period of probation

B. driver who has obtained a driving license

C. one whose driving license been revoked

D. one whose penalty points reach 6 points

Answer: C

24. After the green light at an intersection is on, the vehicles may not yield if non-motorized vehicles cut in.

A. Right

B. Wrong

Answer: B

25. How to use lights when pulling over on road?

A. turn on the hazard lights

B. turn on the right-turn signal in advance

C. use the high and low beam lights alternately

D. not need to use any light to indicate

Answer: B