银川考驾照英文

1. What is this manipulation device?

A. switch of the turn signal

B. switch of the head lights

C. switch of wiper

D. switch of defogger

Answer: D

2. What marking is the road mark?

A. crosswalk ahead

B. intersection ahead

C. reduce speed and yield ahead

D. stop to yield ahead

Answer: A

3. Whats the meaning of this sign?

A. road narrows on the left side

B. narrow bridge

C. narrow road

D. road narrows on the right side

Answer: B

4. How to do in this intersection?

A. wait in the cross-hatched marking area

B. stop and wait outside the intersection

C. follow the vehicle in front and pass

D. wait inside the intersection

Answer: B

5. When driving in icy and snowy weather, the vehicle steadiness decreases and sudden acceleration can very easily cause spins and slides.

A. Right

B. Wrong

Answer: A

6. Which is incorrect when a motorized vehicle breaks down on the expressway?

A. place warning sign as required

B. passengers cannot get off

C. call the police at once

D. turn on the hazard lights

Answer: B

7. When a vehicle stops temporarily in a rainy day, the driver should turn on ______.

A. The head and tail fog lights

B. The hazard lights

C. The high beam light

D. The reverse light

Answer: B

8. Whats the meaning of this sign?

A. watch for pedestrians

B. crosswalk

C. village or town

D. primary school

Answer: C

9. Can not overtake in this situation.

A. Right

B. Wrong

Answer: A

10. What is the max speed on the expressway when the visibility is lower than 100 meters?

A. less than 40km/hr

B. less than 60km/hr

C. less than 80km/hr

D. less than 90km/hr

Answer: A

11. It lights to indicate that ______

A. the head and tail fog lights are turned on

B. front and rear width lights are turned on

C. the head lights are turned on

D. the hazard lights are turned on

Answer: B

12. After the green light at an intersection is on, the vehicles may not yield if non-motorized vehicles cut in.

A. Right

B. Wrong

Answer: B

13. Before a vehicle enters an intersection, the driver should reduce speed, observe and make sure it is safe to do so.

A. Right

B. Wrong

Answer: A

14. Which part does it control when pulling this switch?

A. turn signals

B. reverse light

C. contour light

D. hazard light

Answer: A

15. In which situation the traffic police may detain the vehicle?

A. no lable of inspection

B. no ID card

C. no lable of environmental protection

D. no vehicle registration papers

Answer: A

16. What does this symbol indicate?

A. switch of high beam lights

B. switch of the low beam lights

C. master switch of vehicle lights

D. the switch of tail fog light

Answer: C

17. Whats the meaning of this sign?

A. stop to yield

B. no stopping temporarily

C. no entry

D. no long stopping

Answer: A

18. Driving across the double solid lines is _______

A. rule-breaking act

B. violation of law

C. faulty act

D. violation of regulations

Answer: B

19. How long can a driver drives without rest?

A. less than 6hrs

B. less than 8hrs

C. less than 10hrs

D. less than 4hrs

Answer: D

20. When the driver is suspected of drinking or drunk in a traffic accident, preserve the scene and immediately report to the police.

A. Right

B. Wrong

Answer: A

21. It lights to indicate that ______

A. not buckled up

B. safety belt malfunction

C. the safety belts are too loose

D. buckled up already

Answer: A

22. When overtaking a vehicle stopping on the right side, the driver should ________ in case that vehicle starts up suddenly or opens the door.

A. Speed up and pass

B. Keep honking

C. Maintain the normal speed

D. Keep a safe horizontal distance from that vehicle, reduce speed and pass

Answer: D

23. Max speed when pass the narrow road or bridge is _______

A. 50km/hr

B. 40km/hr

C. 30km/hr

D. 60km/hr

Answer: C

24. When a motorized vehicle breaks down at night, and is difficult to move, the driver should turn on the hazard lights, the contour lights and the tail lights.

A. Right

B. Wrong

Answer: A

25. How to use lights when pulling over on road?

A. turn on the hazard lights

B. turn on the right-turn signal in advance

C. use the high and low beam lights alternately

D. not need to use any light to indicate

Answer: B