资阳学车英语

1. The yellow lane-dividing line on the road is used to _____

A. allow to drive in left lane

B. separate the traffic flow in opposite directions

C. separate the traffic flow in the same direction

D. prohibit to cross the opposite lane

Answer: B

2. Whats the meaning of this guide arrow?

A. going straight and U turn are allowed ahead

B. left turn and U turn are allowed ahead

C. going straight and changing to left lane are allowed ahead

D. going straight and left turn are allowed ahead

Answer: B

3. What marking is the combination of the white broken lines and the triangle area?

A. road entry marking

B. lane-dividing line that can be crossed

C. deceleration line at road exit

D. road exit marking

Answer: D

4. What is the max speed when in or out of the lane for non-motorized vehicles?

A. 40km/hr

B. 50km/hr

C. 60km/hr

D. 30km/hr

Answer: D

5. When encountering an ambulance rushing in the same lane in the opposite direction, the driver should ________.

A. Move to the road side, reduce speed or stop to yield

B. Drive on by using another lane

C. Speed up and change lane to avoid

D. Continue to go in the original lane

Answer: A

6. What is this manipulation device?

A. switch of the turn signal

B. switch of the head lights

C. switch of wiper

D. switch of defogger

Answer: D

7. When driving during the period of probation, the driver should paste or hang _____ on the rear part of the vehicle

A. a mark of avoiding with care

B. a mark of paying attention of beginner

C. a uniform probation mark

D. a mark of paying attention of vehicle distance

Answer: C

8. What is the max speed when passing this curve?

A. 40km/hr

B. 30km/hr

C. 50km/hr

D. 70km/hr

Answer: B

9. After a tire blows out and before the driver can control the speed of the vehicle, he should refrain from using the foot brake to stop the vehicle. Otherwise, a horizontal swing of the vehicle can cause greater danger.

A. Right

B. Wrong

Answer: A

10. Whats the meaning of the yellow marking on the road?

A. gradual road width

B. more carriageways

C. closing to obstacle

D. construction section indication

Answer: A

11. The reason that a road destroyed by flood affects safe driving and smooth passage is __.

A. The road grip becomes stronger

B. It is impossible to see the hidden holes and bumps in road surface

C. The visibility become lower and blurs the field of vision

D. The sunshine reflection blurs the view

Answer: B

12. When a vehicle enters a two-way tunnel, the driver should turn on ________.

A. The hazard lights

B. The high beam light

C. The fog light

D. The width light or the low beam light

Answer: D

13. When encountering an overflowing bridge, the driver should look at the situation, and passes through slowly before he makes sure that it is safe to do so.

A. Right

B. Wrong

Answer: A

14. A motorized vehicle driver who uses falsified and altered vehicle license is subject to a ________.

A. 6-point penalty

B. 3-point penalty

C. 2-point penalty

D. 12-point penalty

Answer: D

15. When driving at night, the driver should try as much as possible to avoid overtaking. When he really needs to overtake, he may switch the high and low beam lights to alert the vehicle in front.

A. Right

B. Wrong

Answer: A

16. When reaching an intersection, the driver should _____ if a turning vehicle cuts in.

A. Stop to evade

B. Maintain the normal speed

C. Speed up and pass ahead of it

D. Honk and pass ahead of it

Answer: A

17. According to rules on the road traffic safety, the maximum speed on the expressway is less than 120km/hr, thus, it will not be in violation of the traffic regulations as long as the speed does not exceed 120km/hr on the expressway.

A. Right

B. Wrong

Answer: B

18. When encountering stopping in turn or slow-moving vehicles in front at an intersection where lanes are reduced, the motorized vehicle should _________.

A. enter the intersection from road shoulder by the right side of the vehicle in front

B. enter the intersection from the side of interspace

C. pass alternately with one vehicle each lane to enter the intersection

D. change to left lane and cut in to enter the intersection

Answer: C

19. When driving in thick or extremely thick fog, the driver should ____ due to low visibility.

A. Turn on the head light and keep driving

B. Turn on the contour light, fog light and drive along the right side

C. Turn on the hazard lights and keep driving

D. Turn on the hazard lights, fog light, and stop at a safe place

Answer: D

20. Whats the meaning of this sign?

A. bump road

B. low-lying road

C. high outburst road

D. hump bridge

Answer: B

21. Whats the meaning of the white solid line in the middle of the road?

A. unilateral same direction lanes dividing line that can be crossed

B. same direction lanes dividing line that can not be crossed

C. bilateral same direction lanes dividing line that can be crossed

D. opposite direction lanes dividing line that can not be crossed

Answer: B

22. When driving on a mountain road covered by ice and snow, the vehicle behind should ______ if the vehicle in front is climbing a slope.

A. Climb slowly

B. Closely follow and climb

C. Select a proper place to stop and climb after the vehicle in front has passed

D. Rapidly overtake the vehicle in front

Answer: C

23. Whats the meaning of this sign?

A. watch for pedestrians

B. watch for children

C. school area

D. crosswalk

Answer: A

24. When overtaking, the driver should ________ if the vehicle in front refuses to reduce speed or yield.

A. Follow closely and find chance to overtake again

B. Stop overtaking

C. Speed up and continue to overtake

D. Continuously honk and speed up to overtake

Answer: B

25. Whats the meaning of this sign?

A. 3m width limit ahead

B. 3m width limit

C. the 3m width limit ban is lifted

D. 3m height limit

Answer: B