玉树2026科目一考试英文版

1. When discovering a vehicle behind wanting to overtake while driving, the driver should _______.

A. Maintain the original speed

B. Reduce speed, observe and run by the right side to yield

C. Speed up and go ahead by the right side

D. Not yield

Answer: B

2. Whitch kind of vehicle is prohibited from passing by this sign?

A. all kinds

B. small bus

C. midsize bus

D. small truck

Answer: B

3. In the course of reversing, the driver should move slowly, observe the conditions on both sides and in the rear and be ready to stop anytime.

A. Right

B. Wrong

Answer: A

4. Which part does it control when rotating this part of the switch?

A. the low beam lights

B. the head and tail fog lights

C. high beam lights

D. turn signals

Answer: B

5. Whats the meaning of this sign?

A. water channel

B. bridge

C. tunnel

D. Culvert

Answer: C

6. A driver may drive a motorized vehicle after the driving license has been lost within 3 months.

A. Right

B. Wrong

Answer: B

7. Whats the meaning of this sign?

A. stop and yield the right side vehicle while crossing each other

B. no passing on the right side road

C. two-way lane section ahead

D. stop and yield the opposite vehicle while crossing each other

Answer: D

8. If one drives an illegally assembled motorized vehicle, he should not only pay the fine, but also ________ .

A. be confiscated the driving license

B. be revoked the driving permission

C. be forced to recover the vehicle condition

D. be revoked the driving license

Answer: D

9. What is this manipulation device?

A. switch of reverse light

B. switch of wiper

C. switch of the hazard lights

D. combination switch of lights and signals

Answer: D

10. Whats the meaning of this sign?

A. no stopping temporarily

B. no long stopping

C. no stopping

D. long stopping is allowed

Answer: B

11. When a vehicle goes downhill on a mountain road, it is not allowed to overtake.

A. Right

B. Wrong

Answer: A

12. It lights to indicate that ______

A. the head and tail fog lights are turned on

B. front and rear width lights are turned on

C. the head lights are turned on

D. the hazard lights are turned on

Answer: B

13. What marking is it?

A. prohibitive area

B. cross-hatched marking

C. guide line

D. central circle

Answer: D

14. Whats the meaning of the white horizontal solid line in the circle?

A. turning waiting line

B. deceleration line

C. yielding line

D. stop line

Answer: D

15. This set of the hand signals of the traffic police indicates that the vehicles should ___ .

A. turn right

B. pull over

C. turn left

D. stop

Answer: D

16. When a vehicle passes a narrow road or bridge, it is prohibited from overtaking.

A. Right

B. Wrong

Answer: A

17. In which section cannot overtake?

A. mountain road

B. urban elevated road

C. urban expressway

D. narrow bridge and curve

Answer: D

18. Whats the meaning of the yellow broken and solid lines in the middle of the road?

A. no crossing the lines on the side of the broken line

B. no crossing the lines on the side of the solid line

C. allowed to cross the lines on the side of the solid line

D. allowed to cross the lines on both sides

Answer: B

19. Whats the meaning of this sign?

A. national boundaries

B. border defense

C. boundaries

D. customs

Answer: D

20. When driving, the driver should be courteous and defensive, instead of being offensive.

A. Right

B. Wrong

Answer: A

21. This sign reminds the lane or the road narrows on both sides ahead.

A. Right

B. Wrong

Answer: B

22. Whats the meaning of this sign?

A. overflowing bridge

B. ferry

C. pier

D. overflowing road

Answer: B

23. Violating the law and regulations on road traffic safety is the act of violation of the law.

A. Right

B. Wrong

Answer: A

24. What pedal is it?

A. accelerator pedal

B. clutch pedal

C. handbrake

D. the brake pedal

Answer: A

25. As the traffic flow at an interchange is generally one-way, the vehicles do not have to reduce speed when passing.

A. Right

B. Wrong

Answer: B