南通驾考科目一英文版

1. How to use lights when overtaking at night?

A. turn off the high beam light

B. turn on high beam lights

C. use fog lights

D. using the high and low beam lights alternately

Answer: D

2. It lights when turning on the front low beam lights.

A. Right

B. Wrong

Answer: B

3. It displays that the current temperature of the coolant is 90 degrees.

A. Right

B. Wrong

Answer: A

4. Whats the meaning of the double white solid lines in far front of the intersection?

A. stopping and yield line

B. slowdown and yield line

C. left-turn waiting line

D. waiting to run line

Answer: A

5. Whats the meaning of this figure mark on the road?

A. a mark of keeping distance

B. a mark of minimum distance

C. a mark of speed limit

D. a mark of road number

Answer: C

6. Turn on the left-turn signal in advance when making a U turn on the road.

A. Right

B. Wrong

Answer: A

7. Cannot make a U turn in this section.

A. Right

B. Wrong

Answer: A

8. When a motorized vehicle crosses a non-motorized vehicle on a narrow road or a narrow bridge at night, the motorized vehicle should use the high beam light.

A. Right

B. Wrong

Answer: B

9. What is the max speed on a road covered by ice and snow

A. 50km/hr

B. 40km/hr

C. 30km/hr

D. 20km/hr

Answer: C

10. It is illegal for a driver to use a cell phone while driving.

A. Right

B. Wrong

Answer: A

11. When driving at night on a road that has good lighting, the driver should use _______.

A. The fog light

B. The low beam light

C. The high beam light

D. The hazard lights

Answer: B

12. What marking are the white broken lines in the circles?

A. small vehicles turning lines

B. lane connection lines

C. non-motorized vehicles guide lines

D. intersection guide line

Answer: D

13. What kind of violation does the vehicle have while temporarily stopping by the roadside?

A. stop in the crosswalk

B. stop more than 30cm from the roadside

C. stop in the section with no stopping marking

D. stop occupying the lane for non-motorized vehicles

Answer: A

14. Driving a motorized vehicle on the expressway is not allowed to exceed the marked maximum speed.

A. Right

B. Wrong

Answer: A

15. This set of the hand signals of the traffic police indicates that the vehicles should ____ .

A. wait to turn left

B. pull over

C. turn left

D. turn right

Answer: C

16. Whats the meaning of this sign?

A. change to right lane

B. branching point

C. road surface becomes wider

D. the number of lanes increases

Answer: D

17. A motorized vehicle driver who reverses, drives in the opposite direction or make a U turn by crossing the central dividing strip on the expressway is subject to a 6-point penalty.

A. Right

B. Wrong

Answer: B

18. When driving a vehicle through an inundated road with pedestrians on both sides, the driver should ________.

A. Speed up and pass

B. Go forward normally

C. Continuously honk

D. Reduce speed and go slowly

Answer: D

19. When the two red lights at a level crossing flash alternately, the vehicles should stop to wait.

A. Right

B. Wrong

Answer: A

20. No turning right when encountering this traffic light at the intersection.

A. Right

B. Wrong

Answer: B

21. In the course of making a U turn, the driver should strictly control the speed, carefully observe the road conditions before and behind the vehicle, and may advance or reverse only if it is safe to do so.

A. Right

B. Wrong

Answer: A

22. Whats the meaning of this sign?

A. intersection ahead

B. interchange ahead

C. Y-shaped intersection ahead

D. ring intersection ahead

Answer: B

23. When encountering stopping and waiting in turn or slow-moving vehicles in front, the motorized vehicle may _________.

A. borrow road to overtake

B. occupy the opposite lane

C. follow the vehicles in front

D. cut in the waiting vehicles

Answer: C

24. A rear tire blowout can sway the tail of the vehicle. The driver should firmly hold the steering wheel with both hands to ensure the vehicle go straight, reduce speed and then stop.

A. Right

B. Wrong

Answer: A

25. When a vehicle passes a bumped road, the driver should ________.

A. Speed up and dash over under inertia

B. Change to the neutral gear and slide over

C. Maintain the original speed and pass

D. Pass slowly and steadily

Answer: D