齐齐哈尔英文版考驾照

1. A motorized vehicle is not allowed to make a U turn at the level crossing, bridge, steep slope, tunnel or dangerous road section.

A. Right

B. Wrong

Answer: A

2. When encountering non-motorized vehicles intending to bypass a stopping vehicle, the driver should ________.

A. Honk to indicate them to yield

B. Yield to them

C. Speed up and bypass

D. Follow them closely and honk

Answer: B

3. When driving in thick or extremely thick fog, the driver should ____ due to low visibility.

A. Turn on the head light and keep driving

B. Turn on the contour light, fog light and drive along the right side

C. Turn on the hazard lights and keep driving

D. Turn on the hazard lights, fog light, and stop at a safe place

Answer: D

4. What is the Minimum speed on this expressway?

A. 100km/hr

B. 80km/hr

C. 60km/hr

D. 50km/hr

Answer: C

5. What is this manipulation device?

A. switch of windscreen wiper

B. switch of the head lights

C. switch of the turn signal

D. switch of defogger

Answer: A

6. When a vehicle on the main road approaches a conjunction with a feeder road, the driver should ______ in order to prevent a collision with a vehicle that suddenly enters from the feeder road.

A. Maintain the normal speed

B. Reduce speed in advance, observe and drive with care

C. Honk and swiftly pass

D. Speed up in advance and pass

Answer: B

7. This set of the hand signals of the traffic police indicates that the vehicles should ____ .

A. turn right

B. change lane

C. reduce speed and pass slowly

D. pull over

Answer: C

8. A driver who drives an illegally assembled motorized vehicle is subject to ______ .

A. being held for criminal liabilities according to law

B. a fine of 200 yuan ~ 2,000 yuan

C. being revoked the vehicle license

D. being detained for less than 15 days

Answer: B

9. Whats the meaning of this sign?

A. no long time honking

B. honk discontinuously

C. reduce speed and honk

D. no honking

Answer: D

10. This set of the hand signals of the traffic police indicates that the vehicles should ___ .

A. turn right

B. reduce speed and pass slowly

C. pull over

D. change lane

Answer: D

11. Which part of the driver can be protected by the safety pillow when there is a rear-end collision?

A. waist

B. chest

C. head

D. neck

Answer: D

12. Whats the meaning of this sign?

A. yield if going to turn left

B. straight one-way road

C. right one-way road

D. left one-way road

Answer: D

13. What is this manipulation device?

A. air conditioner switch

B. ignition switch

C. wiper switch

D. light switch

Answer: B

14. Whats the meaning of the yellow solid line on the curbstone?

A. only for taking and dropping people

B. only for loading and unloading cargos

C. no long stopping

D. no parking

Answer: D

15. This sign indicates indoor car park here.

A. Right

B. Wrong

Answer: B

16. What is the max speed on this highway?

A. 30km/hr

B. 40km/hr

C. 50km/hr

D. 70km/hr

Answer: D

17. Which of the following vehicle in front in the same lane is not allowed to be overtaken?

A. large bus or large truck

B. fire engine on duty

C. public bus

D. taxis

Answer: B

18. Whats the meaning of this sign?

A. no left turn

B. dead-end road

C. no passing

D. bypass if overheight

Answer: D

19. It lights when turning on the left-turn signal.

A. Right

B. Wrong

Answer: B

20. What is this traffic sign?

A. slippery section

B. sharp curve

C. inverse curve

D. continuous curves

Answer: D

21. No U turn at this section.

A. Right

B. Wrong

Answer: B

22. The vehicle with ABS system can minimize the braking distance when driving on a road covered by ice and snow.

A. Right

B. Wrong

Answer: B

23. Using the high and low beam lights alternately while driving on the road of this kind of sharp curve.

A. Right

B. Wrong

Answer: A

24. Whats the meaning of the white markings on the road?

A. road construction marking

B. horizontal deceleration marking

C. vertical deceleration marking

D. fewer lanes indication marking

Answer: B

25. Steering wheel will be locked if removing the key while the ignition switch is in the LOCK position.

A. Right

B. Wrong

Answer: A