海西英文版驾校考试科目一

1. When reaching an intersection, the driver should _____ if a turning vehicle cuts in.

A. Stop to evade

B. Maintain the normal speed

C. Speed up and pass ahead of it

D. Honk and pass ahead of it

Answer: A

2. When ignition switch is in the START position, the starter starts.

A. Right

B. Wrong

Answer: A

3. Whats the meaning of this sign?

A. more vehicles section

B. passing slowly

C. jammed section

D. construction section

Answer: B

4. You can overtake from right side in this case.

A. Right

B. Wrong

Answer: B

5. What is this manipulation device?

A. the air throttle lever

B. the gear lever

C. the clutch lever

D. the handbrake

Answer: D

6. It displays that oil in tank has less than the warning line

A. Right

B. Wrong

Answer: A

7. Whats the meaning of this sign?

A. change to right lane

B. branching point

C. road surface becomes wider

D. the number of lanes increases

Answer: D

8. What causes the rear-end collision?

A. not observe through the rear-view mirror while the vehicle in front brakes

B. the vehicle in front brakes suddenly

C. distance from the vehicle in front is too close when the rear vehicle overtakes

D. not maintain a safe distance from the vehicle in front

Answer: D

9. A motorized vehicle driver who uses falsified and altered license plate is subject to a ________.

A. 2-point penalty

B. 3-point penalty

C. 12-point penalty

D. 6-point penalty

Answer: C

10. This set of the hand signals of the traffic police indicates that the vehicles should ___ .

A. turn right

B. pull over

C. turn left

D. stop

Answer: D

11. Whats the meaning of these white rectangle markings?

A. long time parking

B. time limited parking

C. free parking

D. special parking

Answer: B

12. This sign indicates intersection ahead.

A. Right

B. Wrong

Answer: B

13. The cycle for recording the accumulated penalty points for violating road traffic regulations is ____________.

A. 14 months

B. 12 months

C. 6 months

D. 10 months

Answer: B

14. When crossing each other at night, how far should change the high beam lights to low beam lights?

A. not need to change lights

B. beyond 150m

C. within 100m

D. within 50m

Answer: B

15. What marking is the road mark in the circle?

A. crosswalk line

B. slowdown and yield line

C. stopping and yield line

D. intersection signal line

Answer: A

16. When passing a section of a mountain road which is prone to landside and mudflow, the driver should not stop.

A. Right

B. Wrong

Answer: A

17. What is this traffic sign?

A. slippery section

B. sharp curve

C. inverse curve

D. continuous curves

Answer: D

18. What marking is it?

A. prohibitive area

B. cross-hatched marking

C. guide line

D. central circle

Answer: D

19. When the green light at a congested intersection is on, the vehicles _______.

A. May directly enter the intersection

B. Cannot enter the intersection

C. May pass the intersection by borrowing the opposite lane

D. Enter the intersection if it is safe to do so

Answer: B

20. Use the high and low beam lights alternately when passing the crosswalk at night.

A. Right

B. Wrong

Answer: A

21. Overtaking is allowed when passing a level crossing in city where no train passes.

A. Right

B. Wrong

Answer: B

22. What is this traffic sign?

A. Road narrows on both sides

B. Road narrows on the right side

C. Road narrows on the left side

D. Bridge narrows

Answer: A

23. One can drive the low-speed truck if the authorized vehicle applied for is small motor vehicle with automatic transmission.

A. Right

B. Wrong

Answer: B

24. When braking on a muddy road, the tires can easily spin or drift and cause traffic accidents.

A. Right

B. Wrong

Answer: A

25. A small bus driver should reduce speed rapidly when he suddenly feel bumpy on a flat expressway, to prevent tire blowout.

A. Right

B. Wrong

Answer: A