深圳准备考驾照英语

1. How to use lights when pulling over on road?

A. turn on the hazard lights

B. turn on the right-turn signal in advance

C. use the high and low beam lights alternately

D. not need to use any light to indicate

Answer: B

2. Traffic Signs and traffic markings are not traffic signals.

A. Right

B. Wrong

Answer: B

3. Move the switch up and down, the windscreen wipers start working.

A. Right

B. Wrong

Answer: A

4. When driving in icy and snowy weather, the vehicle steadiness decreases and sudden acceleration can very easily cause spins and slides.

A. Right

B. Wrong

Answer: A

5. Whats the meaning of this sign?

A. Passing on both sides

B. Passing by the right side

C. Passing by the left side

D. Passing is prohibited

Answer: B

6. Traffic lights are divided into red, green and yellow light.

A. Right

B. Wrong

Answer: A

7. Whats the meaning of this sign?

A. lane for small vehicles

B. special lane for small vehicles

C. special lane for multi-passenger vehicles

D. lane for motorized vehicles

Answer: D

8. When a vehicle merges with the traffic flow, the driver should turn on the turn signal in advance, go straight, observe the traffic conditions on both sides through the rear-view mirror, and merge with the traffic flow if it is safe to do so.

A. Right

B. Wrong

Answer: A

9. After starting the engine, it lights to indicate that ______

A. engine main oil way blockage

B. engine oil pressure is too low

C. engine crankshaft box leaks

D. engine oil pressure is too high

Answer: B

10. Whats the meaning of this sign?

A. downhill section on right side

B. driving by the right side of the road

C. stopping by the right side of the road

D. right turn only

Answer: B

11. Whats the meaning of the yellow broken and solid lines in the middle of the road?

A. no crossing the lines on the side of the broken line

B. no crossing the lines on the side of the solid line

C. allowed to cross the lines on the side of the solid line

D. allowed to cross the lines on both sides

Answer: B

12. This sign indicates landslide section ahead and bypassing.

A. Right

B. Wrong

Answer: B

13. Can not overtake in this situation.

A. Right

B. Wrong

Answer: A

14. What marking is the triagle filled area in the circle?

A. stop line

B. deceleration line

C. guide line

D. cross-hatched marking

Answer: C

15. If a motorized vehicle driver has caused a major traffic accident in violation of the traffic regulations which has caused human death due to his escaping, the driver is subject to a prison term of _________.

A. less than 2 years

B. less than 3 years

C. less than 7 years

D. more than 7 years

Answer: D

16. In such road sections, you can enter the cross-hatched marking area to wait.

A. Right

B. Wrong

Answer: B

17. Violating the law and regulations on road traffic safety is the act of violation of the law.

A. Right

B. Wrong

Answer: A

18. If a motorized vehicle driver chases and races while driving on road, commits serious acts, the driver is subject to a prison term of less than 3 years.

A. Right

B. Wrong

Answer: B

19. Whats the meaning of this sign?

A. expressway exit ahead

B. expressway entry ahead

C. expressway ending ahead

D. expressway beginning ahead

Answer: C

20. Whats the meaning of this guide arrow?

A. no passing

B. driving lane

C. merging

D. going straight

Answer: D

21. What kind of lane that the red car running in?

A. fast lane

B. slow lane

C. emergency lane

D. special lane

Answer: A

22. It is a bad habit for a driver to put his left arm on the window of the vehicle or hold the gear lever in his right hand for a long time.

A. Right

B. Wrong

Answer: A

23. The yellow lane-dividing line on the road is used to _____

A. allow to drive in left lane

B. separate the traffic flow in opposite directions

C. separate the traffic flow in the same direction

D. prohibit to cross the opposite lane

Answer: B

24. Full penalty points of a scoring cycle because of violating the traffic regulations is 12 points.

A. Right

B. Wrong

Answer: A

25. 7.When a vehicle changes lane before an intersection, the driver should do so ______.

A. In the area marked by solid lines before the intersection

B. In the area marked by solid lines in the intersection

C. In the area marked by broken lines as indicated by the guide arrow

D. Before the stop line at the intersection

Answer: C