南宁科目四模拟考试英文版

1. A driver should accelerate in advance to overtake then it is likely to meet with oncoming vehicles.

A. Right

B. Wrong

Answer: B

2. Before setting off, it is necessary to check the driving cabin, engine cabin, external and tires of the motor vehicle.

A. Right

B. Wrong

Answer: A

3. The white solid line on the right side of the road indicates the boundary of a driving lane and crosswalk.

A. Right

B. Wrong

Answer: B

4. The marking on the road surface indicates that the speed limit of this road section is 50 km/hour.

A. Right

B. Wrong

Answer: A

5. When encountering this situation in a residential area the driver should speed up and pass in front of the bicycle.

A. Right

B. Wrong

Answer: B

6. What should the driver do if the back wheel slides to the right on a muddy road?

A. Continuously speed up

B. Turn right

C. Turn left

D. Apply emergency brake

Answer: B

7. The sign on the right indicates a bypass route at the intersection ahead.

A. Right

B. Wrong

Answer: A

8. When driving on a damp and slippery road, drivers should avoid using the emergency brake to his best ability.

A. Right

B. Wrong

Answer: A

9. When a motor vehicle temporarily stops at night, which lamp should be turned on?

A. Front and rear fog lamp, clearance lamp and rear position lamp

B. Head lamp, clearance lamp and rear position lamp

C. Hazard lamp, clearance lamp and rear position lamp

D. Reverse lamp, clearance lamp and rear position lamp

Answer: C

10. The sign on the right indicates that the number of the lanes ahead will increase.

A. Right

B. Wrong

Answer: B

11. When a tire suddenly bursts on the road, what should not be done by the driver?

A. Keep calm and release the accelerator pedal slowly

B. Hold the steering wheel firmly to ensure the vehicle goes straight

C. Apply emergency braking and stop the vehicle in the shortest possible time

D. Gently depress the brake pedal after the vehicle slows down

Answer: C

12. The sign in front indicates a temporary parking lot on the right side of the highway.

A. Right

B. Wrong

Answer: B

13. When encountering such a situation, the vehicles should cut speed or stop to yield as approaching each other.

A. Right

B. Wrong

Answer: A

14. What should the driver do when seeing these hand signals?

A. Go straight and pass through the intersection

B. Stop in front of the stop-line and wait

C. Turn left at the intersection

D. Drive at a lower speed at the intersection

Answer: C

15. What should the driver do when the motor vehicle passes a flyover?

A. Speed up and pass rapidly

B. Keep the speed under 15 km/hour

C. Drive at the speed indicated by the traffic sign

D. Drive close to the central line of the flyover

Answer: C

16. The sign on the right warns of an uneven road ahead.

A. Right

B. Wrong

Answer: A

17. When the motor vehicle encounters a crosswalk in this situation, the driver may speed up and pass rapidly.

A. Right

B. Wrong

Answer: B

18. The guide arrow on the road surface of this lane indicates that only U-turns are permitted at the intersection ahead.

A. Right

B. Wrong

Answer: B

19. What should the driver do when seeing these hand signals?

A. Turn left at the intersection

B. Stop and wait

C. Go straight at the intersection

D. Drive to the waiting area for turning left

Answer: B

20. How many kinds of law-breaking acts are displayed in flash 2?

A. One

B. Two

C. Three

D. Four

Answer: B

21. The sign on the right warns of a wildlife protection area ahead.

A. Right

B. Wrong

Answer: B

22. Where is the proper parking place for breakdown motor vehicles stopping for examination?

A. In the far outer lane

B. In the inner lane

C. In the emergency lane

D. Entrance area of the ramp

Answer: C

23. Motor vehicle drivers should rush to the top of the slope in this situation.

A. Right

B. Wrong

Answer: B

24. The sign on the right warns of a guarded crossing 150 meters ahead.

A. Right

B. Wrong

Answer: B

25. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D