长沙考驾驶证英语

1. It lights to indicate that ______

A. the tail fog light is turned on

B. the low beam light is turned on

C. the high beam light is turned on

D. the head fog light is turned on

Answer: D

2. After starting the engine, it lights to indicate that ______

A. engine main oil way blockage

B. engine oil pressure is too low

C. engine crankshaft box leaks

D. engine oil pressure is too high

Answer: B

3. Whats the meaning of this sign?

A. tunnel entry

B. observatory

C. mind side wind

D. wind vane

Answer: C

4. It lights to indicate that ______

A. handbrake released

B. foot brake failure

C. braking system is abnormal

D. the brake pedal does not return back

Answer: C

5. Whats the meaning of this sign?

A. Y-shaped intersection

B. T-shaped intersection

C. intersection

D. ring intersection

Answer: B

6. What kind of device the safety bags are?

A. ABS system

B. electronic brake force distribution system

C. assisted occupants protection system

D. drivers head and neck protection system

Answer: C

7. Whats the meaning of this sign?

A. water channel

B. bridge

C. tunnel

D. Culvert

Answer: C

8. When driving slowly in a congested road, the driver should ________ if another vehicle forcefully cuts in.

A. Honk to warn it against cutting in

B. Speed up to closely follow the vehicle in front and refuse to allow it to cut in

C. Squeeze the cutting-in vehicle to force it to leave

D. Voluntarily yield to ensure safe driving

Answer: D

9. After the green light at an intersection is on, the vehicles may not yield if non-motorized vehicles cut in.

A. Right

B. Wrong

Answer: B

10. What is this instrument?

A. pressure meter

B. ammeter

C. water temperature meter

D. fuel meter

Answer: D

11. How to make a U turn in this intersection?

A. broken lines of the central line

B. make a U turn from the right lane

C. enter the intersection and make a U turn

D. make a U turn in the crosswalk

Answer: A

12. If a vehicle may encounter a vehicle coming in the opposite direction in the course of overtaking, the driver should speed up in advance and overtake.

A. Right

B. Wrong

Answer: B

13. Whats the meaning of this sign?

A. landslide section

B. construction section

C. factory ahead

D. jammed road

Answer: B

14. Rear fog light lights when the light switch is at this position.

A. Right

B. Wrong

Answer: A

15. This set of the hand signals of the traffic police indicates that the vehicles should ___ .

A. wait to turn left

B. pull over

C. turn right

D. reduce speed and pass slowly

Answer: C

16. What is the minimum speed in this lane?

A. 60km/hr

B. 90km/hr

C. 100km/hr

D. 110km/hr

Answer: C

17. Driving on the expressway with full signs and marking, the driver should run in the lane and at the speed according to _________.

A. Signs and markings

B. Rules on road traffic safety

C. Vehicle manual

D. Local regulations

Answer: A

18. The vehicles should run by the right shoulder of an expressway.

A. Right

B. Wrong

Answer: B

19. After a vehicle enters a mountain road, it should pay special attention to the continuous curves sign. In addition, it should voluntarily evade vehicles and pedestrians, reduce speed in a time manner and honk in advance.

A. Right

B. Wrong

Answer: A

20. If a motorized vehicle driver drives on the road after getting drunk is subject to a prison term of more than 3 years.

A. Right

B. Wrong

Answer: B

21. What kind of marking is the yellow broken line in the center of the road?

A. indicative marking

B. prohibitive marking

C. warning sign

D. auxiliary marking

Answer: A

22. When a motorized vehicle encounters the cut in by another vehicle in a roundabout, the driver may not evade as long as he has the right of way.

A. Right

B. Wrong

Answer: B

23. A motorized vehicle is not allowed to stop in the section 50 meters to the intersection.

A. Right

B. Wrong

Answer: A

24. Whats the meaning of this sign?

A. national boundaries

B. border defense

C. boundaries

D. customs

Answer: D

25. Continuously using the foot brake on a long downhill road ________.

A. Can shorten the engines service life

B. Increases the drivers labor intensity

C. Can drastically reduce the braking efficiency due to the rising temperature of the brake

D. Can easily cause vehicle overturn

Answer: C