铜仁英语版驾考科目一

1. How to pass this intersection?

A. keep the speed and go through

B. honk to urge

C. reduce speed and go through slowly

D. speed up and go through

Answer: C

2. This sign indicates intersection ahead.

A. Right

B. Wrong

Answer: B

3. When encountering non-motorized vehicles intending to bypass a stopping vehicle, the driver should ________.

A. Honk to indicate them to yield

B. Yield to them

C. Speed up and bypass

D. Follow them closely and honk

Answer: B

4. What is this manipulation device?

A. switch of reverse light

B. switch of wiper

C. switch of the hazard lights

D. combination switch of lights and signals

Answer: D

5. When a vehicle passes a level crossing, it is prohibited from overtaking.

A. Right

B. Wrong

Answer: A

6. How to do when encountering slow-moving vehicles in front?

A. follow the vehicles in front

B. occupy the opposite lane to overtake

C. borrow the lane from right side to overtake

D. overtake from both sides as will

Answer: A

7. Whats the meaning of this sign?

A. straight-going lane

B. going straight only

C. one-way road

D. no going straight

Answer: B

8. It lights to indicate that engine oil may be insufficient.

A. Right

B. Wrong

Answer: A

9. When a motorized vehicle makes a U turn, turns around or goes down a slope, the maximum speed should not exceed 40 kilometers per hour.

A. Right

B. Wrong

Answer: B

10. It is not safe for a woman driver to wear high heels to drive a vehicle.

A. Right

B. Wrong

Answer: A

11. Which kind of sign is it?

A. tourist zone sign

B. work area sign

C. notification signs

D. expressway sign

Answer: A

12. In which situation the traffic police can detain the vehicle according to law?

A. exceeding 10% of the prescribed speed limits

B. driving when he is exhausted

C. not buckled up while driving

D. driving after drinking

Answer: D

13. Ignition switch in the ON position, the vehicle can not use electrical appliances.

A. Right

B. Wrong

Answer: B

14. This sign warns the driver to run slowly with care and beware of the vehicles from horizontal road.

A. Right

B. Wrong

Answer: A

15. If a front tire blowout has caused a turn in direction, the driver should not avoid excess adjustment. Instead, he should control the direction of the vehicle, ____, and slowly reduce the speed of the vehicle.

A. Apply emergency braking

B. Use the handbrake

C. Gently depress the brake pedal

D. Swiftly depress the brake pedal

Answer: C

16. The main impact of foggy weather on safe driving is _________.

A. The engine can easily stop

B. The vehicle can easily slide sideways

C. The resistance the vehicle increases

D. The visibility is low and the vision is poor

Answer: D

17. What is the max speed at sharp curve?

A. 20km/hr

B. 30km/hr

C. 40km/hr

D. 50km/hr

Answer: B

18. When a vehicle passes a level crossing, the driver should use the low gear to pass and should not change gear halfway in order to avoid engine kill.

A. Right

B. Wrong

Answer: A

19. How to do in this intersection?

A. wait in the cross-hatched marking area

B. stop and wait outside the intersection

C. follow the vehicle in front and pass

D. wait inside the intersection

Answer: B

20. Which kind of sign is it?

A. warning sign

B. prohibitive sign

C. indicative sign

D. directional sign

Answer: C

21. Whats the meaning of this sign?

A. driving at reduced speed in the section of 40 meters

B. minimum speed is 40km/hr

C. maximum speed is 40km/hr

D. 40km/hr speed limit ban is lifted

Answer: D

22. It lights to indicate that ______

A. left-turn signal flashes

B. front and rear width lights light on

C. front and rear width lights light on

D. right-turn signal flashes

Answer: A

23. The validity of the driving license which is initially applied for is ______

A. 3 years

B. 5 years

C. 6 years

D. 12 years

Answer: C

24. A motorized vehicle driver who uses falsified and altered license plate is subject to a ________.

A. 2-point penalty

B. 3-point penalty

C. 12-point penalty

D. 6-point penalty

Answer: C

25. Registration alternation is not needed when _____

A. change engine

B. add anti-collision device

C. change vehicles colour

D. change the chassis

Answer: B