银川英文驾考科目

1. Before the motorized vehicle runs on the road, the driver should check the safety and technical performance of the vehicle.

A. Right

B. Wrong

Answer: A

2. After starting the engine, it lights to indicate that ______

A. fuel pump abnormal or malfunction

B. ignition system malfunction

C. fuel supply system is abnormal

D. fuel in tank reaches the minimum level

Answer: D

3. You have the priviledged passing right of way in this situation.

A. Right

B. Wrong

Answer: A

4. It lights to remind that the driver‘s seat is not adjusted properly.

A. Right

B. Wrong

Answer: B

5. When a vehicle changes lane, the driver should turn on the turn signal and rapidly enter the new lane.

A. Right

B. Wrong

Answer: B

6. How to make a U turn in this intersection?

A. broken lines of the central line

B. make a U turn from the right lane

C. enter the intersection and make a U turn

D. make a U turn in the crosswalk

Answer: A

7. Whats the meaning of this guide arrow?

A. going straight or U turn

B. going straight or left turn

C. going straight or changing to left lane

D. left turn or U turn

Answer: B

8. As thick fog reduces visibility, turning on the high beam light can increase the visibility.

A. Right

B. Wrong

Answer: B

9. What marking is the two white broken lines in the circle?

A. stop lines at crossroad

B. left-turn waiting areas

C. U turn guide lines

D. small vehicles turning lines

Answer: B

10. Whats the meaning of this sign?

A. bus station of expressway

B. rest area of expressway

C. gasoline station of expressway

D. service area of expressway

Answer: C

11. What is the max speed when visibility is less than 50m due to foggy, rainy or snowy?

A. 70km/hr

B. 50km/hr

C. 40km/hr

D. 30km/hr

Answer: D

12. When a vehicle reaches a muddy or burst-and-muddy section, the driver should stop,observe and select the level and solid section or the section with vehicle tracks.

A. Right

B. Wrong

Answer: A

13. Registration alternation is not needed when _____

A. change engine

B. add anti-collision device

C. change vehicles colour

D. change the chassis

Answer: B

14. You can drive directly into the expressway from this position.

A. Right

B. Wrong

Answer: B

15. When a vehicle enters a two-way tunnel, the driver should turn on ________.

A. The hazard lights

B. The high beam light

C. The fog light

D. The width light or the low beam light

Answer: D

16. It lights to indicate that the handbrake may not loose in the end.

A. Right

B. Wrong

Answer: B

17. When a vehicle stops for a long time, the driver should select a car park to do so.

A. Right

B. Wrong

Answer: A

18. Whats the meaning of this sign?

A. tunnel entry

B. observatory

C. mind side wind

D. wind vane

Answer: C

19. Whats the meaning of this guide arrow?

A. left curve or need to merge with the left flow ahead

B. right curve or need to merge with the right flow ahead

C. merge with the left flow due to right side obstacle ahead

D. left curve or need to bypass from left side ahead

Answer: A

20. When there is a diversion traffic control on the expressway, a driver can stop by the side to wait instead of leaving out of the expressway, for continually running after the traffic control.

A. Right

B. Wrong

Answer: B

21. Whats the meaning of this sign?

A. location and distance

B. driving route

C. destination name

D. driving direction

Answer: A

22. Whats the meaning of this sign?

A. flat intersection

B. flat ring intersection

C. attention to interactive intersection

D. attention to separate intersection

Answer: D

23. Move the switch up and down, the windscreen wipers start working.

A. Right

B. Wrong

Answer: A

24. The continuously flashing yellow light means that the vehicle may speed up and pass.

A. Right

B. Wrong

Answer: B

25. In which situation the traffic police may detain the vehicle?

A. no lable of inspection

B. no ID card

C. no lable of environmental protection

D. no vehicle registration papers

Answer: A