郑州驾照考试科目一英文版

1. The yellow lane-dividing line on the road is used to _____

A. allow to drive in left lane

B. separate the traffic flow in opposite directions

C. separate the traffic flow in the same direction

D. prohibit to cross the opposite lane

Answer: B

2. How long is the period of probation after a motorized vehicle driver obtains his driving license for the first time or the permission to drive higher level vehicles.

A. 6 months

B. 12 months

C. 2 years

D. 3 months

Answer: B

3. The starter works when turning the ignition switch to the ACC position.

A. Right

B. Wrong

Answer: B

4. What marking is the yellow broken line in the circle?

A. non-motorized vehicles guide lines

B. intersection guide line

C. lane connection lines

D. small vehicles turning lines

Answer: B

5. Whats the meaning of this sign?

A. no left turn

B. dead-end road

C. no passing

D. bypass if overheight

Answer: D

6. Whats the meaning of this sign?

A. embankment road

B. dangerous hillside road

C. rock-falling road

D. cliffside road

Answer: B

7. Whats the meaning of this sign?

A. no left turn

B. leftt and right turn

C. no leftt and right turn

D. no right turn

Answer: B

8. This set of the hand signals of the traffic police indicates that the vehicles should ____ .

A. turn right

B. change lane

C. reduce speed and pass slowly

D. pull over

Answer: C

9. When running on an expressway that has four lanes in the same direction, the vehicles whose speed is higher than 110 kilometers per hour should run ______.

A. The far left lane

B. The second left lane

C. The far right lane

D. The third left lane

Answer: A

10. Driving a small passenger vehicle on the expressway, the minimum speed should not be less than 90 kilometers per hour.

A. Right

B. Wrong

Answer: B

11. The method of this small passenger vehicle to leave the expressway lane is correct.

A. Right

B. Wrong

Answer: A

12. Whats the meaning of this sign?

A. observation deck

B. car park

C. rest area

D. parking space

Answer: A

13. It lights to indicate that ______

A. front and rear width lights light on

B. front and rear width lights light on

C. left-turn signal flashes

D. right-turn signal flashes

Answer: D

14. Whats the meaning of this sign?

A. provincial highway No.

B. county road No.

C. township road No.

D. national highway No.

Answer: C

15. Whats the meaning of this sign?

A. Passing on both sides

B. Passing by the right side

C. Passing by the left side

D. Passing is prohibited

Answer: C

16. Whats the meaning of this sign?

A. bypass at construction section

B. two-way traffic

C. bypass from left or right side

D. watch for danger

Answer: C

17. What kind of sign is it?

A. directional sign

B. indicative sign

C. prohibitive sign

D. warning sign

Answer: A

18. When a vehicle reaches a sharp curve, the driver should _______.

A. Brake suddenly and go slowly

B. Drive along the outer side of the curve

C. Fully reduce speed and drive on the right side

D. Go forward by borrowing the opposite lane

Answer: C

19. What marking are the white serrated solid lines in the circle?

A. guide lane lines

B. direction guide line

C. variable guide lane line

D. one-way driving line

Answer: C

20. It lights to indicate that ______

A. the tail fog light is turned on

B. the low beam light is turned on

C. the high beam light is turned on

D. the head fog light is turned on

Answer: B

21. When a following vehicle gives the overtaking signal, the driver should ________ if conditions permit.

A. Move to the right side and speed up

B. Voluntarily reduce speed and drive along the right side

C. Yield a proper space and speed up

D. Reduce speed rapidly or apply an emergency braking

Answer: B

22. A motorized vehicle is not allowed to make a U turn at the level crossing, bridge, steep slope, tunnel or dangerous road section.

A. Right

B. Wrong

Answer: A

23. Whats the meaning of this sign?

A. school area

B. watch for children

C. crosswalk

D. watch for pedestrians

Answer: B

24. When the light switch is rotated to the position, the whole car lights turn on.

A. Right

B. Wrong

Answer: B

25. When a vehicle enters a two-way tunnel, the driver should turn on ________.

A. The hazard lights

B. The high beam light

C. The fog light

D. The width light or the low beam light

Answer: D