嘉峪关驾考英文版科目四

1. How should lamps be used when motor vehicle drivers pass through a two-way tunnel?

A. Turn on the hazard lamps

B. Turn on the high-beam

C. Turn on the fog lamp

D. Turn on the low-beam

Answer: D

2. Motor vehicle drivers don’t need to use any lamp at night when passing through a road section where the street light condition is good.

A. Right

B. Wrong

Answer: B

3. What should be taken note of by drivers in this situation?

A. The motor vehicles on the left side

B. The motor vehicles on the right side

C. The motor vehicles behind

D. The motor vehicles in front

Answer: A

4. The sign on the right warns of a dangerous mountainside road on the left of the road ahead.

A. Right

B. Wrong

Answer: B

5. The yellow broken line on the curb indicates that vehicles are not allowed to stop and let passengers embark or disembark or load and unload freight at the roadside.

A. Right

B. Wrong

Answer: B

6. The sign in the red circle indicates that vehicles except non-motor vehicles are not allowed to drive in this lane.

A. Right

B. Wrong

Answer: A

7. The sign on the right indicates that overtaking is allowed on the section ahead.

A. Right

B. Wrong

Answer: B

8. How will the adhesive force of road change when speed increases on a damp and slippery road?

A. Increase sharply

B. Increase gradually

C. decrease sharply

D. No change

Answer: C

9. The broken white line rectangle area on the right side of the road indicates that long stopping is permitted here.

A. Right

B. Wrong

Answer: B

10. As shown in the flash, the motor vehicle chooses a correct way to pass through the level crossing.

A. Right

B. Wrong

Answer: A

11. Which one of the following is the safest way when driving a motor vehicle on this road?

A. Cutting speed or stopping to yield

B. Driving along the center of the road

C. Keeping a normal speed

D. Approaching vehicles by taking the opposite lane

Answer: A

12. Which is the wrong measure to avoid tire burst?

A. Reduce tire pressure

B. Check tires regularly

C. Remove foreign matters from the tire tread grooves timely

D. Replace tires that have cracks or deep cuts

Answer: A

13. When approaching another vehicle at night, why should the driver alternate between high-and-low-beam at a distance more than 150 meters?

A. Warn each other before passing

B. Driving habit

C. Easy to observe the situation ahead from either side

D. Courtesy

Answer: C

14. Motor vehicles are not permitted to change lanes in this position.

A. Right

B. Wrong

Answer: A

15. The motor vehicle equipped with ABS may sideslip during an emergency brake.

A. Right

B. Wrong

Answer: A

16. When driving on the expressway in a heavy rain, what should the driver do to avoid water sliding phenomenon?

A. Install slide-proof devices

B. Speed up

C. Slow down

D. Continue to depress the brake

Answer: C

17. How many kinds of law-breaking acts are displayed in flash 1?

A. One

B. Two

C. Three

D. Four

Answer: B

18. The sign on the right side indicates that turning left is not permitted at the intersection ahead.

A. Right

B. Wrong

Answer: A

19. When a vehicle encounters a strong side wind, the driver should firmly hold the steering wheel and press the brake urgently if he feels the vehicle deviates horizontally from the normal direction.

A. Right

B. Wrong

Answer: B

20. The area in the yellow rectangle markings on the right side of the road indicates that temporary stopping is permitted here.

A. Right

B. Wrong

Answer: B

21. Motor vehicles are prohibited from turning left in this situation.

A. Right

B. Wrong

Answer: A

22. After a motor vehicle falls into water, the driver won’t be able to open the side doors or windows to escape until water nearly fills up the compartment.

A. Right

B. Wrong

Answer: A

23. When passing another vehicle on a foggy day, what should drivers do?

A. Slow down and pass slowly

B. Maintain a safety distance

C. Properly use lamps

D. Drive at a high speed

Answer: ABC

24. What should motor vehicle drivers do under such circumstances at night?

A. Turn off the headlamp when approaching

B. Use low-beam

C. Use high-beam

D. Turn off all lamps in advance

Answer: B

25. How should lamps be used when setting off in this situation?

A. Turn on the high-beam

B. Turn on the left indicator only

C. Turn on the left indicator and low-beam

D. Turn on hazard lamp

Answer: C