郑州2026考驾驶证英文试题

1. When a vehicle leaves an expressway, it should reduce speed in the deceleration lane before entering the ramp.

A. Right

B. Wrong

Answer: A

2. When crossing each other on a narrow road, the driver should slow down, yield and stop first.

A. Right

B. Wrong

Answer: A

3. Whats the meaning of the white horizontal solid line in the circle?

A. turning waiting line

B. deceleration line

C. yielding line

D. stop line

Answer: D

4. When a driver drives a motorized vehicle during the period of probation, the driver should paste or hang a uniform probation mark on the rear part of the vehicle.

A. Right

B. Wrong

Answer: A

5. When a vehicle goes downhill, it may fully use the neutral gear and slide.

A. Right

B. Wrong

Answer: B

6. Steering wheel will be locked if removing the key while the ignition switch is in the LOCK position.

A. Right

B. Wrong

Answer: A

7. If the driver finds there is no vehicle following, he can change lanes without turning on the turn signal.

A. Right

B. Wrong

Answer: B

8. The driver who drives after drunk is subject to ______

A. a criminal restriction and a fine

B. a prison term of more than 2 years

C. a criminal detention and a fine

D. a prison term of less than 2 years

Answer: C

9. Whats the meaning of this sign?

A. expressway bus station ahead

B. expressway shelter ahead

C. expressway service area ahead

D. expressway toll station ahead

Answer: C

10. 7.When a vehicle changes lane before an intersection, the driver should do so ______.

A. In the area marked by solid lines before the intersection

B. In the area marked by solid lines in the intersection

C. In the area marked by broken lines as indicated by the guide arrow

D. Before the stop line at the intersection

Answer: C

11. It lights to indicate that ______

A. not buckled up

B. safety belt malfunction

C. the safety belts are too loose

D. buckled up already

Answer: A

12. A front tire blowout is very dangerous. The vehicle will immediately turn to the side where the tire is blown out and have a direct impact on the drivers control of the steering wheel.

A. Right

B. Wrong

Answer: A

13. Whats the meaning of this sign?

A. bypass from left side

B. continuous curves

C. sharp left curve

D. sharp right curve

Answer: C

14. The double yellow solid lines in the middle of the road are used to separate the traffic flow in opposite directions, crossing the lines to overtake or make a turn is allowed if it is safe.

A. Right

B. Wrong

Answer: B

15. When a vehicle goes uphill on a mountain road, it should change to a lower gear in a timely, accurate and rapid manner so as to avoid a situation in which driving at a high gear can reduce the power of the engine.

A. Right

B. Wrong

Answer: A

16. In which section cannot overtake?

A. main streets

B. elevated road

C. crosswalk

D. ring express

Answer: C

17. Whats the meaning of this sign?

A. no changing lane

B. no left turn

C. no going straight

D. no U turn

Answer: D

18. When a vehicle passes a curve on a mountain road, the driver should reduce speed, honk and stick to the right.

A. Right

B. Wrong

Answer: A

19. When a vehicle passes a narrow road or bridge, it is prohibited from overtaking.

A. Right

B. Wrong

Answer: A

20. You may speed up to go through the intersection in this case.Answer：

A. Right

B. Wrong

Answer: B

21. What is this traffic sign?

A. Road narrows on both sides

B. Road narrows on the right side

C. Road narrows on the left side

D. Bridge narrows

Answer: B

22. What kind of behavior of this driver violates the law?

A. not hold the steering wheel according to regulation

B. angle of the seat is not correct

C. not buckled up

D. the driving posture is incorrect

Answer: C

23. How to use lights when entering the speed-reducing lane?

A. turn on the hazard lights

B. turn on the head light

C. turn on the left-turn signal

D. turn on the right-turn signal

Answer: D

24. What marking is the triagle filled area in the circle?

A. stop line

B. deceleration line

C. guide line

D. cross-hatched marking

Answer: C

25. What mark is the inclined yellow and black lines?

A. entity mark

B. protrusions mark

C. three-dimensional mark

D. deceleration mark

Answer: C